POWDP1570 EN
Copyright © 2018 VARO P a g e | 9 www.varo.com
9.6 Switching ON/OFF
▪ Switching on: Press the operating switch (5).
▪ Switching off: Release the operating switch (5).
9.6.1 Switch lock (Fig. 4)
The switch trigger can be locked in the centre position.
This helps to reduce the possibility of accidental starting when not in use. To lock the switch
trigger, place the direction of rotation selector in the centre position.
9.6.2 Direction of rotation (Fig. 5)
Direction of rotation is controlled by the direction of rotation selector located above the switch
trigger.
9.6.2.1 Clockwise rotation:
Right: To select forward rotation, release the on/off switch and push the forward/reverse lever
to the left side of the tool.
9.6.2.2 Anticlockwise rotation:
Left: To select reverse rotation, push the lever to the right side of the tool.
9.6.3 Variable speed
This tool has a variable speed switch that delivers higher speed and torque with increased
trigger pressure.
Speed is controlled by the amount of switch trigger depression.
9.7 Handle attachment (Fig. 6)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle
attachment. Loosen and turn the handle attachment in an ant-clockwise direction. Slip loop
onto the neck of the housing tool and position the handle, then tighten the handle attachment.
9.8 Depth stop
Loosen the handle attachment and place the straight part of the depth stop in the hole. Adjust
the depth stop and retighten the handle attachment.
9.9 Dust collection device
Before carrying out hammer-drilling work vertically overhead pull dust collecting device over
the drill bit.
9.10 Function mode selector
