POWAIR0011 EN
Copyright © 2019 VARO P a g e | 4 www.varo.com
Automatic lubrication is also possible using the supplied mini oiler that you have to install
between the threaded connector of the tool and the male coupler. Make sure that the oiler
is always filled with suitable oil.
Fig. 1
1. Tool
2. Quick connector
3. Quick coupler
4. Air hose
5. Quick connector
6. Quick coupler
7. Lubricator
8. Regulator (0-8.5 bar)
9. Filter
10. Cut-off valve
11. Air compressor
8 LOADING AND OPERATION (FIG. 2 & FIG. 3)
▪ Before each use, drain water out of air compressor tank and condensation from air
lines. After clearing air compressor moisture and lubricating the die grinder, connect it
to an air hose of a recommended compressor.
▪ Use the hand wrenches equipped to remove the cap for replacing the collet and to
install grinding stones.
▪ Since the speed of this die grinder is 22,000rpm, they can quickly remove a lot of
material - sometimes more than you want. Therefore, it is important to use a gentle
touch for many jobs. Stop often and blow away debris to check progress.
9 MAINTENANCE
This die grinder requires lubrication BEFORE initial use and BEFORE and AFTER each
additional use throughout its life.
▪ WARNING!I Disconnect the die grinder from the air supply and hold the tool upside
down.
▪ Pull the trigger, put a half teaspoon of air tool oil into the muffle cover.
▪ Reconnect the die grinder to the air supply and cover the exhaust port with a towel
and run for 20 seconds. Oil will discharge from the rear exhaust port when air
pressure is applied. Any excess oil in the motor is immediately expelled from the
exhaust port. WARNING! Always direct exhaust port away from people or objects.
10 STORAGE
The die grinder must be lubricated before storing. Only run for 3 seconds instead of 20
seconds because more oil needs to remain in the tool when storing.
11 TECHNICAL DATA
