480970
11
Zoom out
Zoom in
Previous page
1/17
Next page
POW8560
EN
Copyright © 2012 VARO P a g e | 11 www.varo.com
8.3 Workpiece stops
8.3.1 Mitre angle stop
The stop can be adjusted by a maximum of 120mm for mitre cutting.
Risk of injury! Do not push the stop (A) too far in the direction of the saw
blade. The gap between the stop (A) and the saw blade should be
approximately 2 cm.
8.3.2 Mitre cuts
Push the mitre angle stop (11) into the required bar of
the table surface.
Loosen adjusting screw (A), set the required angle and
then tighten the adjusting screw again.
If necessary, push the stop plate (c backwards or
forwards. For this, loosen both adjusting screws (B),
push stop plate (C) and then retighten adjusting screws
(B).
8.3.3 Setting the stop rail of the parallel stop
The stop rail can be removed and repositioned after both wing nuts have been loosened:
High stop edge:
To saw tall workpieces.
Low stop edge:
To saw flat workpieces.
If the saw blade is angled.
8.3.4 Parallel stop
Loosen the locking lever (4) (press upwards).
Set the parallel stop to the required cutting width by
pushing on the scale.
Press down the locking lever (4).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POW8560 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POW8560 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POW8560

Powerplus POW8560 User Manual - German - 18 pages

Powerplus POW8560 User Manual - Dutch - 17 pages

Powerplus POW8560 User Manual - French - 18 pages

Powerplus POW8560 Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info