Before starting the engine, do not connect the electric equipment / Sluit geen electronische apparaten aan voordat de generator aanstaat
1.Open the fuel tank air vent to the “OPEN” position / Open de fuel tank air ventiel en draai deze naar “OPEN”
2.Turn the fuel cock lever to the “ON” position / Zet de fuel cock lever op positie “ON”
3.Turn the engine switch to the “ON” position ? Zet de engine switch op positie “ON”
4.When first time to use the generator sets, pressing the primer bulb 6 times after refuel gasoline / Wanneer de generator voor het eerst of lange periode niet is gebruikt druk dan de
primer bulb minimal 6 x in. U ziet brandstof verschijnen in de primer bulb
5.Turn the choke lever to the “││”CHOKE” position. Not necessary if the engine is warm / Zet de choke op de positie “CHOKE” bij
een koude start
6.Pull the starter handle slowly until resistance is felt. This is the “Compression” point. Return the handle to its original position and pull
swiftly. Do not fully pull out the rope. After starting, allow the starter handle to return to its original position while still holding the handle.
Grasp the carrying handle firmly to prevent the generator from falling over when pulling the recoil starter / Trek de generator aan met de
7.starter hendel. Doe dit met beleid en zorg ervoor dat niet het hele koord wordt uitgetrokken. Het koord rolt dmv een veer vanzelf weer op.
8.Houdt de generator met een hand tegen en trek met de andere hand aan het koord
9.Warm up the engine / warm de motor op
10.Turn the choke lever back to the “││RUN ” position / Wanneer de motor loopt zet de choke lever op positie “RUN”
Warm up the engine without a load for a few minutes / Warm de motor een paar minute op voor dat deze in gebruik wordt gesteld
2）USING ELECTRIC POWER / GEBRUIK VAN STROOM
1. AC APPLICATION
(a)Check the AC pilot lamp for proper voltage / Controleer de AC pilot lamp of deze op aan staat
(b)Turn off the switch(es) of the electrical appliance(s) before connecting to the generator / Zet het electronisch apparaat uit voor deze aan te
sluiten op de generator
(c)Insert the pulg(s) of the electrical appliance(s) into the receptacle / Sluit de stekker aan op de generator
CAUTION / WAARSCHUWING:
Be sure the electric equipment is turned off before plugging in / Weet zeker dat het electronisch apparaat is uitgeschakeld
Be sure the total load is within generator rated output / Weet zeker dat het electronisch apparaat binnen bereik van de generator valt
Be sure the socket load current is within socket rated current / Gebruik de juiste stekker
The economy control switch must be turned to “OFF” when using electric devices that require a large starting current, such as a
compressor or a submergible pump / Wanneer de max wattage wordt gevraagd zet de economy switch op “OFF” bij het starten van het electrisch apparaat
2．OVERLOAD INDICATOR LIGHT
The overload indicator light comes on when an overload of a connected electrical device is detected, the inverter unit overheats, or the AC output voltage rises. The electronic breaker will
then activate, stopping power to the generation in order to protect the generator and any connected electric devices. The output pilot light (green) will flicker and the overload indicator light
(red) will turn on, then the engine will stop running. If so please follow the following steps / Het overload indicator light gaat aan wanneer er: te zware apparaten worden aangesloten,
overhitten van de generator en verhoging van de voltage AC Output. De electronic breaker wordt geactiveerd , er wordt dus geen stroom meer geleverd om te generator te beschermen.
Voorkom dit altijd.
(a)Turn off any connected electric devices and stop the engine / Zet alle electrische apparaten uit
(b)Reduce the total wattage of connected electric devices within the application range / Verlaag het gevraagde vermogen
(c)Check for blockages in the cooling air inlet and around the control unit. If any blockages are found, remove / Zorg dat de generator vrij staat en voldoende lucht kan aanzuigen
(d)After checking, restart the engine / Na controle motor opnieuw opstarten
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Powerkick 2000 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Powerkick 2000 in the language / languages: English, Dutch as an attachment in your email.
The manual is 1,77 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
