627530
43
Zoom out
Zoom in
Previous page
1/78
Next page
Owners Manual
R
PowerBoss, Inc. A Member of the Hako Group ©
2007 PowerBoss
®
CORE 50 Sweeper Scrubber
Page 41
PowerBoss
®
The Power of Clean
SERVICE INSTRUCTIONS (CONTINUED)
SWEEP COMPONENTS
BROOM DOOR FLAP INSPECTION
1. Turn the machine off and lock the parking brake.
2. Inspect broom door flaps for wear and damage. Flap clearance should be
⅛” (3.18 mm) above the floor.
3. Worn and damaged flaps should be replaced immediately to maintain
proper dust control.
BROOM DOOR FLAP REPLACEMENT AND ADJUSTMENT
The flaps are attached to the broom doors by a retainer bar, hex bolts and nuts. To
remove the flaps, remove the nuts, bolts and retainer bar. To adjust the flaps, loosen the
nuts and bolts, slide the flap up or down as needed. Retighten the nuts and bolts.
MAIN BROOM ADJUSTMENT
1. Drive the machine onto the test surface with the main broom in the
RAISED position.
2. Set the parking brake and position the main broom float handle in the
NORMAL (UP) position.
3. Push the broom control switch to the ON position to activate the broom
motor and open the throttle to the full RPM.
4. Allow about 45 seconds for the broom to operate, then deactivate the
broom motor and raise the broom.
5. Drive the machine clear of the test site.
6. Examine the polished pattern made by the broom on the test area.
7. If visibility of the polished pattern is difficult, draw a rectangle on the floor
surface using chalk. Fill this area with chalk shading. Position the machine
so that the main broom is above this shaded rectangle and repeat the test.
NOTE
Perform this inspection when the machine is parked on a level surface.
NOTE
Perform this adjustment on a flat, smooth test surface.
NOTE
Test time will vary according to the test surface used.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerBoss Core 50 - Sweeper Scrubber at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerBoss Core 50 - Sweeper Scrubber in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info