766753
6
Zoom out
Zoom in
Previous page
1/30
Next page
6 - 30
Rear Panel Features
1. Cooling Vents.
Front to rear forced airflow.
Do not distruct air vents.
WARNING! Do not use switch 2 or 4
during operation. Only switch them
when amplifier is switch off!
2. Crossover Frequency Range
Selector to select the range of the filter
frequency.
x1 = 45-960Hz, x10 = 450-9600Hz
3. Crossover Frequency
Adjust the crossover frequency.
4. Filter Selection Switch
HIGH= High pass filter
LOW= Low pass filter
BYPASS= No filter, full range
5. Unbalanced 6.3mm Stereo Jack inputs.
Two 6.3mm jack female input connector
for connecting a signal source (mixer etc.).
6. Balanced XLR inputs.
Two 3-pin female XLR input connector for
connecting a signal source (mixer etc.).
7. Limiter Switch
Limiter for the automatic level limitation.
8. Mode Switch.
The amplifier can use 3 different modes:
stereo, bridge & parallel (mono). Choose
one of these functions:
Stereo mode: Standard left/right stereo
mode.
Bridge mode: This mode combines both
amps on one channel which results in
double power on this channel. Connects
the signal to the left input channel and the
output level can now be adjusted with the
left volume control.
9. Ground Lift Switch.
Allows circuit and chassis grounds to be
separated in case of problems with earth
loops (hum).
10. Bridge Speaker Outputs NL4.
Minium load in bridge mode 4 Ohm. Pin
+1 & +2 = + output, Pin -1 & -2 = - output
11. Binding Post Output Jacks.
Minium load in stereo mode 2 Ohm per
channel. Minium load in bridge mode 4
Ohm.
12. Stereo Speaker Outputs NL4.
Minium load in stereo mode 2 Ohm. Pin
+1 & +2 = + output, Pin -1 & -2 = - output.
13. Mains Power Cable
To connect to a mean power socket (220-
240Vac / 16A)
14. Circuit Breaker
This main fuse secures the amplifier and
wires against defects. To reset the
breaker press down the button with the
unit switched off.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Power Dynamics 171.193 - PDA-B1500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Power Dynamics 171.193 - PDA-B1500 in the language / languages: English, German, Dutch, Spanish as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info