648709
17
Zoom out
Zoom in
Previous page
1/22
Next page
| 33 |
17. CLEANING THE HEPA FILTER
(extraordinary maintenance)
17.1 Ensure that the appliance is switched off and disconnected
from the mains.
17.2 Lift the water filter collector removing it from its housing
using the container handle.
17.3 Lift the release lever of the HEPA filter and remove it from
its housing.
17.4 Rinse the HEPA filter using running water only and shake
gently to remove any excess dirt or water residue; before
replacing the filter in the appliance, leave to dry naturally away
from sources of heat for at least 24 hours.
The HEPA filter should be fully cleaned approximately three
times per year.
18. SPARE SEALS
Periodically check the status of the coloured washer located in
the built-in socket. If necessary, replace with the corresponding
spare part, as described below.
Perform the same check on the connection seals of the
extension tubes and the handle of the hose. If necessary,
operate as follows.
19. STORAGE
19.1 Turn off the appliance and disconnect from the mains
electricity.
19.2 Remove the water filter collector as indicated in Chapter 1.
19.3 Manually wind the cable evenly and replace it into the
holder, passing it into the power cable storage space.
19.4 Replace the water filter collector in its housing, making sure
to position it correctly.
19.5 The hoses, brush and flexible hose can be housed on the
body of the appliance, sliding the hook on the universal brush
into the parking system on the appliance.
The hook is present only on extension tubes. Incorrect
assembly of the two extension tubes will prevent the use of
the appliance parking system.
- Remove the damaged washer.
- Insert the new washer, applying it on the
steam nozzle and pushing it into place.
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quanti-
ties of vegetable oil.
- Remove the damaged washer.
- Insert the new washer, attaching it on the
steam nozzle and pushing it into place.
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quanti-
ties of vegetable oils.
To clean the water filter collector and the extension tubes, if
they are especially dirty, once the cleaning operations have
been completed, empty the container as described and
replace it in its housing in the machine. Connect the appliance
to the mains.
Then vacuum up approximately 1.5 litres of clean water using
the suction function for a few seconds. The water vortex
created inside the collector will rinse the sides and remove any
dirt. The clean water will also clean the inside of the tubes as
it travels through them. Empty the collector again and put
Vaporetto Lecoaspira away.
WARNING: Check the filters during cleaning. Replace the filters
when visibly damaged.
WARNING: Do not clean the filter with the brush as it can be
damaged, thereby reducing its filtering capacity. Do not use
detergents, do not rub the filter, and do not wash it in a
dishwasher.
ENGLISH
PRELIMINARE LECOASPIRA FAV20_30 - 2015_vers7:UNICO 22/04/2015 10.45 Pagina 33
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polti Vaporetto Lecoaspira FAV20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polti Vaporetto Lecoaspira FAV20 in the language / languages: English as an attachment in your email.

The manual is 3,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti Vaporetto Lecoaspira FAV20

Polti Vaporetto Lecoaspira FAV20 User Manual - German - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info