648734

Polti Vaporella Silence Friendly 8.85 Manual

10
Zoom out
Zoom in
Previous page
1/15
Next page
ENGLISH
| 22 |
1. PREPARATION FOR USE
1.1 Place the boiler on a firm, flat and heat-resistant surface.
1.2 Remove the self-filling tank lid (1) and fill the tank with about
1.2l of water, making sure that it does not overflow.
This operation must always be carried with the power cable
disconnected from the mains.
Thanks to the continuous refill system you do not need to stop the
ironing and wait for the appliance to cool down because the tank
can be filled as needed.
1.3 Replace the lid.
1.4 Connect the cable plug to an earthed power supply of the
correct voltage (2).
1.5 Press the ON/OFF switch (located on the side of the
machine) (3). The ON indicator light and the “Iron heating”
indicator light will turn on.
1.6 Press the boiler switch (4). The “steam ready” and boiler
indicator lights will come on.
2. IRON TEMPERATURE ADJUSTMENT
Before ironing an item of clothing, always check the symbols
on its label, for the instructions provided by the manufacturer.
Check, based on the following table, the most appropriate type
of ironing:
3. STEAM IRONING
3.1 Make sure that chapter 1 has been completed and regulate
the temperature of the iron (5)-(6) as described in chapter 2.
3.2 Wait for the “Steam Ready” indicator light and “Iron
Heating” indicator light to turn off (about 3 minutes).
3.3 Adjust the steam flow by turning the knob in a clockwise
direction to increase the jet of steam (7). Turning it in an
anticlockwise direction reduces the steam flow.
3.4 Press the steam button (8) on the iron to make steam come
out of the holes on the plate. Releasing the button, the flow
stops. Proceed to iron the garments.
3.5 To have a continuous jet of steam move the button forward
(9). The steam will continue to come out even when the button
is released. To interrupt the supply, move the button backward
(9).
4. VERTICAL IRONING
It is possible to use the iron vertically to remove creases from
fabrics and/or to freshen up the fibres, eliminating possible
residual odours.
Hold the iron vertically, push the steam button (8) and touch the
fabric slightly with the soleplate, if the type of fabrics allows it.
5. DRY IRONING
5.1 Make sure that chapter 1 has been completed, leaving the
boiler switch off and regulate the temperature of the iron (5)-
(6) as described in chapter 2.
During dry ironing, if the boiler button is ON, take care not to
push the steam release button on the Iron since some water
drops can come out from the soleplate
ATTENTION: Do not place the hot iron on any surface.
Vaporella is equipped with an iron rest mat with soft non-slip
inserts designed to resist high temperatures.
The indicator lights “Iron heating” turn on and off during use.
This indicates that the electrical resistor has started to work to
keep the pressure of the boiler steady. This is a normal
occurrence, and it is therefore possible to continue ironing.
When first using the steam, there may be some drops of water
leaking out of the plate, this is due to imperfect thermal
stabilization. We therefore recommend that the first jet of
steam be directed onto a cloth (clean rag).
Divide the laundry according to the symbols on the garment
labels or according to the kind of fabric. Always start ironing
with the garments that require the lowest temperature, in
order to reduce the waiting times and avoid the risk of burning
the fabrics.
ATTENTION: For low temperature we do not recommend the
use of steam since water could come out from the holes on the
soleplate. For medium temperature alternate the use of steam
and dry ironing to avoid water leaking from the holes on the
soleplate.
High temperature – cotton, linen:
Set the iron temperature adjustment knob to the position
•••
Medium temperature – wool, silk:
Set the iron temperature adjustment knob to the position
••
Low temperature – synthetic, acrylic, nylon, polyester:
Set the iron temperature adjustment knob to the position •
- Do not iron
- Steam ironing and steam treatment not allowed
WARNING: When first operating steam, there may be some
drops of water mixed with the steam due to temperature
imbalances.
Direct the first jet of steam onto a rag.
The sound emitted on switching on your appliance and
periodically during use, is due to the water refilling system and
is quite normal.
PRELIMINARE VL FOREVER 8.85-8.80 - 1P05_vers7:UNICO 17/07/2015 15.37 Pagina 22
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polti Vaporella Silence Friendly 8.85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polti Vaporella Silence Friendly 8.85 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti Vaporella Silence Friendly 8.85

Polti Vaporella Silence Friendly 8.85 User Manual - German - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info