Manual Polti Vaporella Forever 655 Pro (page 11 of 16) (English)

648737

Zoom out

Zoom in

1/16

described in chapter 2.

6. OUT OF WATER

The lack of water in the tank is indicated by

the flashing of the indicator light (17) and the

buzzer.

To restart operations just fill the water tank

again as described in the chapter 1.

7. GENERAL MAINTENANCE

Before carrying out any maintenance on the

device, always unplug it from the power

mains making sure that the product has coo-

led down before proceeding.

To clean the outside of the appliance, only use

a damp cloth.

Do not use detergents of any type.

For good maintenance of the boiler we sug-

gest using Kalstop, the special natural-base li-

mescale, distributed by Polti, and available for

sale at all major domestic-appliance stores or

online at www.polti.com.

Clean the iron soleplate when it is completely

cold with a damp cloth or with a non-abrasive

sponge.

8. CLEANING THE BOILER

(extraordinary maintenance)

To maintain optimum performance, clean the

boiler every 10/20 uses depending on the

amount of limestone in the water.

8.1 Unplug the appliance and let it cool down

for 2 hours at least, if it is hot.

8.2 Empty the water tank to prevent leakage.

8.3 Turn the appliance upside down and lift

the rubber cover. Unscrew the cap of the boi-

ler situated on the bottom of the appliance

(22) with a suitable screwdriver.

8.4 Use the funnel to pour 250 ml of cold wa-

ter into the boiler (23).

8.5 Rinse out the boiler and pour the water

away into the sink or into a container for col-

lecting dirty water. If the water is very dirty,

repeat the operation until it is clean.

8.6 Put 100 ml of water in the boiler and

screw back the cap. Make sure that the seal is

in and the cap is screwed on properly.

8.7 Fill the water tank again and put the cap on.

8.8 Turn the appliance on again.

Before ironing, release steam into the sink or

another container and check that the steam is

clean. This should take a few seconds.

8.9 Resume ironing normally.

9. REPLACEMENT BOILER CAP GA-

SKET (not supplied)

If the gasket of the boiler cap is damaged, re-

place it with the specific spare part, as descri-

bed below:

9.1 Unplug the appliance and let it cool down

for 2 hours at least, if it is hot.

9.2 Empty the water from the tank to prevent

leaking.

9.3 Turn the appliance upside down and lift

the rubber cover. Unscrew the cap of the boi-

ler situated on the bottom of the appliance

(22) with a suitable screwdriver.

9.4 Remove the damaged washer.

9.5 Insert the new gasket and push it in place

(24).

9.6 Screw the boiler cap back on, making sure

that it is correctly screwed on and replace the

rubber cover.

The spare gasket can be purchased from

WARNING: Risk of scalding! When accessing

the boiler (removing the cap, ﬁlling up,

emptying), ensure that the appliance is swit-

ched off at the power switch and disconnec-

ted from the mains for at least two hours.

WARNING: Steam.

Risk of scalding!

WARNING: Do not exceed the quantity of

water recommended and pour it slowly into

the boiler, paying attention not to let it over-

flow.

WARNING: Risk of scalding! When acces-

sing the boiler (removing the cap, ﬁlling up,

emptying), ensure that the appliance is swit-

ched off at the power switch and disconnec-

ted from the mains for at least two hours.

WARNING: Steam.

Risk of scalding!

WARNING: This operation must always be

done after having disconnected the applian-

ce from the mains.

During dry ironing, if the boiler button is ON,

take care not to push the steam release but-

ton on the Iron since some water drops can

come out from the soleplate

ENGLISH

| 23 |

VL FOREVER 625-630-635-650-655 - M0S10308 - 1P05:FEV 1000-950.qxd 10/06/2015 11.49 Pagina 23

There is water leaking from a bottom of the unit forever 655. What can be done? Submitted on 17-5-2022 at 13:49
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Polti Vaporella Forever 655 Pro in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti Vaporella Forever 655 Pro

Polti Vaporella Forever 655 Pro User Manual - German - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Polti Vaporella Forever 655 Pro Manual

Product: