648804

Polti Sani System Polti Manual

8
Zoom out
Zoom in
Previous page
1/8
Next page
S
S
H
H
O
O
R
R
T
T
A
A
G
G
E
E
O
O
F
F
W
W
A
A
T
T
E
E
R
R
I
I
N
N
T
T
H
H
E
E
B
B
O
O
I
I
L
L
E
E
R
R
The water in the boiler may run out if the
recharging system is not working properly.
This type of malfunctioning is signalled by the
lamp (D) starting to flash and by a buzzer. If
the problem persists contact the service cen-
tre.
T
T
R
R
A
A
N
N
S
S
P
P
O
O
R
R
T
T
This device can be moved easily by means of
the transport grip (I) on the rear of the device
or using the two side handles. If required, the
transport grip can be removed by unscrewing
the two wing screws on the rear of the handle.
WARNING: Never drag the device by the
nozzle. Move it only by means of the grip (I)
or the two side handles.
S
S
T
T
O
O
R
R
I
I
N
N
G
G
T
T
H
H
E
E
D
D
E
E
V
V
I
I
C
C
E
E
.
.
When you have finished using the device, put
it away in a clean and dry place after discon-
necting it from the power mains. Keep it away
from sources of heat and protect from the
weather. Do not expose the device to extreme
temperatures. Disconnect the tank (Q) from
the nozzle before putting it away or when the
device will not be used for some time.
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
Before carrying out any maintenance on
the device, always unplug it from the power
mains and allow it to cool down before pro-
ceeding.
If the monotube is torn, it must be replaced by
an authorised service centre.
Cleaning of the delivery nozzle
Clean the delivery nozzle every 10-15 hours of
use. Clean the delivery nozzle using the brush
(T) included in the supply, sliding it inside the
tube so as to remove any residues of scaling in
it (Fig.8).
Lubrication of the coupling
Whenever it is difficult to fit the connector (Q)
and in any case when the device has not
been used for some time, lubricate the cou-
pling on the bottom of the delivery device
(fig.9) with a synthetic lubricant. It you find it
difficult to insert the connector even after lu-
bricating, contact an authorized service cen-
ter.
Tips
In the event of external factors such as, for ex-
ample, a sudden change in voltage due to an
upset in the network (failure, lightning, etc.),
the device may be affected by electrical inter-
ference and be subject to temporary malfunc-
tioning.
To reset the device, switch it off and discon-
nect it from the mains for a few minutes. After
this procedure, start it again normally. If it still
does not work correctly, ask for a check up at
an authorised service centre.
Having the device checked after a problem of
this kind is recommended.
External cleaning
For cleaning the outside of the device we rec-
ommend using a damp cloth. Do not use sol-
vents or detergents as these could damage
the surfaces. Pay special attention to the
cleanliness of the outside of the device when
moving from one room to another, cleaning the
wheels too.
WARNING: For all other maintenance pro-
cedures and whenever necessary, contact
an authorised service centre. Do not at-
tempt under any circumstances to disas-
semble the device or to open it.
SANI SYSTEM POLTI
39
E
E
N
N
G
G
L
L
I
I
S
S
H
H
SANI SYSTEM 02 M0S08288 1O05:A5 06/06/2008 17.05 Pagina 39
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polti Sani System Polti at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polti Sani System Polti in the language / languages: English as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info