622065
17
Zoom out
Zoom in
Previous page
1/25
Next page
The scanner allows you to skip undesired frequencies from search or scanning.
Just press SKIP on such a frequency and the frequency will be marked on the ´display
with “SKIP
During next search cycle the scanner will not any more stop on this frequency.
To disable the skip function again, just go to the desired frequency and press SKIP once
more - you will see SKIP disappearing from the display.
Memory Scanning
Now you have successfully saved a couple of frequencies into the scanners memory lo-
cations. If you like to check only these stored frequencies, then press RECALL and press
Start-Stop to start, stop or restart the scanning.
Hints:
If you do not have any frequency stored in the scanners memory, the display will show
No.dAtA
If the scanner picks up too much noise or stops at noisy signals, you should increase the
squelch level setting.
To listen to more distant stations, it may be necessary to reduce the squelch level or to
use the MONITOR key on the left side to open the squelch.
When the scanner finds a transmission, it will stop there. To avoid a too early restart after
a signal disappeared, we recommend to add a delay of some seconds.
Please note that scanner specialist have a special name for stored frequencies: they
call them now channels.
Scanning channels means: scanning all memory locations one after the other for
known stations.
Searching means: scanning the bands from a start frequency to a stop frequency for
Frequencies which are just in use or for still unknown stations.
Setting the frequency steps:
In the German pre programmed band plan, the frequency steps are pre-defined (e.g. in
the 4 m Band)
In other bands, it is possible to change the steps according to the transmission parame-
ters which are used there.
Where necessary, go to the desired band and change the steps with the keys F + STEP
and select with UP/DOWN. In all bands, the possible steps may be different.
The step selection may be especially useful in the CB band, because CB is using worldwide
10 kHz steps with + 5 kHz offset (the display shows “5 ”), and only in Poland they use 10
kHz without any offset, where the display shows “0 ”.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polmar RX-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polmar RX-5 in the language / languages: English as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info