Manual Polisport Guppy Maxi Plus (page 7 of 63) (All languages)

773026

Zoom out

Zoom in

1/63

| 4 | www.polisport.com

1. Unscrew the hand knob (G1) and simultaneously lift the red security

ring (G2). Open the jaw (G3) to an aperture wider than the luggage carrier.

2. Place the seat on the luggage carrier and then fasten the hand knob

(G1) so that the seat remains slightly attached to the luggage carrier.

Check if the jaw (G3) is properly fastened to the luggage carrier.

3. Fasten the hand knob (G1) so that the seat is well attached to the

luggage carrier. As soon as the hand knob is well tightened, make sure the

security lever is properly held as shown in the picture.

4. The child seat has a centre of gravity (F) (inscribed on the child seat) that

must be positioned in front of the rear wheel axle. If it is positioned behind

the axle, the distance must not exceed 10 cm. If the centre of gravity is

more than this distance from the axle, adjust the seat to the correct

position. Special care must also be taken when positioning the child seat

to ensure that the cyclist does not touch the child seat with his feet when

cycling. Make sure that the mounting plate (G) is ﬁrmly attached to the

carrier before proceeding. This step is extremely important for child and

cyclist safety. Check the safety of the fasteners regularly.

Note: In Germany, according to the German Traﬃc Law StVZO, bicycle

seats may only be ﬁxed so that 2/3 of the seat depth or the Gravity Center

of the seat is located between the front and rear axle of the bicycle..

5. Pass the safety belt (C) around the bicycle frame. Adjust it as shown

in the picture, under tension. Make sure that remain loosen belt is not in

contact with the wheel. This step is extremely important for the child’s

safety.

6. To place the child in the seat, ﬁrst fully extend the belt straps (B), sliding

the adjusters (B2). This makes it easier to put the child in the seat. To put

the child in the seat, open the lock (B1) of the safety belt (B) and press the

three buttons of the lock (B1) as indicated. According to the child growth

you can adjust the height of the belt on the hole for belt adjustment (B4).

Note: Before starting the journey, always check that the child is secured

and that the belt is snug but not so tight that it hurts the child. We

recommend that the child’s helmet be put on after the belt is adjusted.

7. To adjust the height of the footrest (E) to ﬁt your child, release the

footrest (E) from the seat (A) by pressing the two fasteners together and

lift the footrest as indicated in the picture (it may be necessary to apply

some pressure to the fasteners).

8. To reattach the footrests, ﬁrst engage the top pin, and push the footrest

(E) down to lock the clips into the slots holes.

9. To guarantee your child’s safety, adjust the strap (D) of the footrest.

Unlock the strap (D) and adjust it to the child’s foot. Lock it again making

sure the strap does not hurt the child.

10. Do not exceed the maximum limit of 1kg of weight supported by the

transport net (J). In total the maximum weight of the child and the objects

on the net, can’t exceed the recommended 22kg.

11. Make sure you have followed and fulﬁlled all the instructions given.

When done so, the child bicycle seat is ready for use. IT IS MANDATORY

TO READ the following chapter on safety instructions about using your

child bicycle seat.

For child safety and for your peace of mind, Polisport has developed the

perfect child carrying solution that’s suitable for a wide range of adult

bicycles.

Our ergonomic child seats are all built with safety and comfort as the

primary goals.

In this manual, you will ﬁnd the information to attach the baby seat to

the carrier.

Carefully read the manual for a safe and correct installation of the child

bicycle seat.

ASSEMBLY INSTRUCTIONS

REAR CHILD SEAT FOR BICYCLE

CARRIER MOUNTING SYSTEM

• This child bicycle seat must not be mounted to bicycles ﬁtted with rear

shock absorbers.

• This child bicycle seat must not be mounted to a racing bicycle with

drop handlebar.

• This child bicycle seat must not be mounted to Motorized Vehicles such

as Mopeds and Scooters.

• The child bicycle seat must be assembled on a carrier with a load capacity

of 25kg, according to the ISO 11243 standard.

• The maximum weight applied to the carrier cannot exceed 25kg.

• For safety reasons this seat shall only be ﬁtted to luggage carriers in

accordance with ISO 11243 - 120 to 175 mm. Note: This seat also ﬁts wider

carriers – 185 mm.

• The child bicycle seat must be assembled on bicycles with wheels with

diameters of 26” and 28”.

• This child bicycle seat is only suitable for carrying children with a

maximum weight of 22 Kg (and children with recommended ages ranging

from 9 months to 5 years of age - with the weight as the decisive variable).

• The total weight of the cyclist and the child transported must not exceed

the maximum permitted load permitted for the bicycle. Information on

the maximum load can be found in the operating instructions of the

bicycle. You can also contact the manufacturer for this question.

• The seat may only be mounted on a bicycle suitable for the attachment

of such additional loads.

• The position of the child bicycle seat must be adjusted so that the bicycle

rider does not touch the child bicycle seat with the feet when in motion.

• It’s very important to adjust correctly the seat and its component parts

for optimum comfort and safety of the child. It’s also important that the

seat does not slope forward, so that the child does not tend to slide out of

it. It’s also important that the backrest slope backward slightly.

• Check if all parts of the bicycle function correctly with the child bicycle

seat mounted.

• Check the instructions of the bicycle, and If you have any doubts

on ﬁtting the child bicycle seat to your bicycle, please contact your

bicycle supplier for further information.

TECHNICAL FEATURES

A. Main seat

B. Safety belt

B1. Safety lock

B2. Belt adjuster

B3. Central belt adjuster

B4. Hole for belt adjustment

C. Safety belt for bicycle frame

D. Footrest strap

E. Footrest

F. Centre of Gravity

G. Mounting plate to luggage

carrier

G1. Hand knob

G2. Safety red ring

G3. Jaw

H. Cushion

I. Batch serial number

J. Transport net

TABLE OF CONTENTS OF PRODUCT

• The rider must be at least 16 years of age; Check legislation and national

regulations pertaining to this.

• Make sure that the weight and height of the child do not exceed the

maximum capacity of the seat, and check this at regular intervals. Check

INSTRUCTION FOR USE

Detach the safety-belt (C) in order to remove the child seat. To remove

the seat from the luggage carrier, unfasten the hand knob (G1) and lift

simultaneously the red security ring (G2) in order to open the jaw (G3)

wider than the width of the luggage carrier.

HOW TO REMOVE YOUR CHILD BICYCLE SEAT

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Polisport Guppy Maxi Plus in the language / languages: All languages as an attachment in your email.

The manual is 2.83 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Polisport Guppy Maxi Plus Manual

Product: