234192

Plextor dvd recorder px 504a Manual

16
Zoom out
Zoom in
Previous page
1/56
Next page
Section 2. Installing Your PX-504A
10
PX-504A Installation and Users Manual
Figure 3: Removing a Typical Computer's Cover
Determine Your Existing IDE Configuration
With your computer open, determine the existing IDE configuration. You can do this
by looking at the 40-pin IDE ribbon cable (or cables—there may be two) and seeing
what is connected to them.
One end of the IDE cable is connected to a port on the computer’s motherboard; and
the other end is connected to one or two peripheral devices (such as a hard disk or
CD-ROM drive). If there are two devices, one is configured as Master and the other
the Slave, as indicated by the position of jumpers on the back of the drive.
In the case of the Cable Select bus, both devices must be jumpered as Cable Select.
This configuration requires a special Cable Select cable.
If there are two IDE ports, one is for the primary IDE bus and the other is for the
secondary bus.
Before you install your PX-504A, your computer’s IDE configuration is usually one
of the following:
•
Configuration A: Hard disks connected as Master and Slave devices on primary
IDE port; CD-ROM drive connected as the Master device on secondary IDE port.
•
Configuration B: Hard disk connected as Master device and DVD or CD-ROM
drive connected as Slave on the primary IDE port; nothing connected to
secondary IDE port.
•
Configuration C: Hard disk connected as Master device on primary IDE port;
nothing connected to secondary IDE port.
•
Configuration D: System uses special “Cable Select” cables; all devices are
jumpered for Cable Select.
Downloaded from www.Manualslib.com manuals search engine
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Plextor dvd recorder px 504a at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Plextor dvd recorder px 504a in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info