491792
4
Zoom out
Zoom in
Previous page
1/20
Next page
Correct way to hold scrivo.1
When using a typical ballpoint pen, you can
write on a paper regardlessof how you hold the
pen. On the other hand, if you hold a fountain
pen and rotate its pen tip to an upright posi-
tion, you cannot write at all since the tip of a
fountain pen has a different structure to that of
a typical ballpoint pen. Similarly, the performan-
ce of scrivo.1 greatly depends on how you hold
it. As a result, when you try to write a memo
or draw a simple graph with scrivo.1, holding it
incorrectly may result in unexpected output
such as rotated letters, tilted axis and so on.
Therefore, you should be careful when you hold
scrivo.1
.
The Ccorrect way to hold scrivo.1 is shown in the pictures below. The forepart, where the push
button is attached, should face the front
If the angle of scrivo.1 and the surface is too low as shown in the figure (a), or if its forepart
does not face to the front as shown in the figure (b), (c), and (d), it will not perform correctly.
Front View Side View
(a) Angle of pen and surface
is too low.
(b) scrivo.1 is turned to right.
(c) scrivo.1 is reversed. (d) scrivo.1 is turned to left.
3. Using scrivo.1
scrivo.1 has a power switch, two function buttons, and two indicators.
Power switch
Turn the power ON/OFF using this switch located on the bottom of the pen. Power switch must
be in the ON position before use. Switch to the OFF position if it’s not in use for a long period of
time.
Pairing Button
Reset the pen to initial stage. After successful initiation, Status LED light will blink green
continuously.
First button (pen-tip button)
Located on the end of scrivo.1 and has same function as the left button on a typical mouse.
Second button (Jog button)
Located on the front top of the pen and has same function as the right button on typical mouse.
When you scroll the Jog switch, it will work like the mouse wheel scroll feature.
Status-LED
1) Green LED -> indicates status between Pen and Charger is ok.
- Blinking continuously: Initiating stage for pairing. (Blinking for the first 3 mins remain lit after
3 mins)
- No LED light: Complete Pairing Status.
- Continues to blink in 1-2 sec. interval: Power to receiver has been interrupted
2) Red LED – Check battery status
- Need to recharge scrivo.1 when red LED blinks (continues to be usable for 30 mins)
Battery indicator
Red LED during charging and green LED when fully charged. Total charging time: 3.5 hours.
Status-LED
First Button
Second button
Battery indicator
Pairing Button
Power switch
6 7
scrivo1_manual_eng_rz_kb2.qxd 06.12.2004 17:39 Uhr Seite 6
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Plawa Scrivo 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Plawa Scrivo 1 in the language / languages: English as an attachment in your email.

The manual is 4,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Plawa Scrivo 1

Plawa Scrivo 1 User Manual - German - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info