717408
33
Zoom out
Zoom in
Previous page
1/40
Next page
33
Adjustment screw
4. Repeat the adjustment procedure for all burners.
Pressure Testing
1. Remove left hand pan support and front left burner cap and crown.
2. Fit manometer tube over the injector.
3. Turn on the burner gas supply and ignite another burner.
4. Turn off the burner supplies.
2.8 Conversion from NG to LPG/LPG to NG
DANGER! The conversion must be carried out by an authorized professional
only!
Check on the appliance which gas category is suitable. The gas supply can be
converted provided that the correct injectors are installed and the gas flow rate is
adjusted properly.
1. Set all control knobs to OFF ( ).
2. Disconnect the appliance from the electricity supply.
3. Remove pan supports, burner caps, rings, crowns and control knobs.
4. The injectors can be replaced by relevant ones using a 7 mm box spanner.
Adjustment of the gas flow rate
With the aid of a thin bladed screwdriver completely tighten down the bypass
adjustment screw, which is located below the centre of the gas tap control shaft.
Upon completion stick the replacement rating plate on the bottom side of the hob.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PKM GKM4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PKM GKM4 in the language / languages: English, German as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info