455261

Pioneer VSX-C300 Manual

26
Zoom out
Zoom in
Previous page
1/56
Next page
26
En
Crossover frequency setting mode
Crossover frequency is the point where the receiver divides
the high and low sounds (the frequencies) between the
speakers. Since most smaller speakers can’t handle deep
bass tones, this setting allows you to send those sounds to
the subwoofer (or speakers set to “Large”) instead of the
speakers set to “Small” in your system. Choose the point at
which you want the frequency routed to the subwoofer.
We recommend setting this to 200 Hz if smaller book-
shelf-type speakers are used for your “Small” speakers.
Fine Tuning Your Surround Sound
SPEAKERS (Front, Center, Surround)
setting mode
This setting establishes the size and configuration of the
speaker system you have connected more exactly than the
automatic setup. Set here, for example, what speakers you
have connected and which size they are. Selecting “Large”
or “Small” will determine if bass sounds are sent by the
receiver to the speakers being set.
In the display, “F”, “C”, and “S” refer to front, center,
and surround speakers respectively. Speaker size is
denoted as “L” for large speakers, “S” for small speakers,
and “_” (underscore) if no speaker is connected.
Below is a diagram showing exactly what each display for
the speaker setup means and how to decide whether to
choose “Large”, “Small” or none ( _ ) for your set up.
If you only have two speakers none of the below will not
match your setup. In this case just ignore this setting and
choose the appropriate 2 channel listening mode (see
page 30) for what you want to hear.
LARGE: If the cone size (diameter) of your speaker(s) is
larger than 12 centimeters, set to “Large”.
SMALL: If the cone size (diameter) of your speaker(s) is
12 centimeters or smaller, set to “Small”.
None( _ ): Choose this setting if you have no speaker(s)
hooked up to this terminal. Sound coming from this
channel in the original source will be down-mixed to one
of the active speakers.
Follow steps 1-3 on page 25.
Use the % or fi buttons to choose a speaker
setting mode according to the speakers you
hooked up.
The configurations shown above will appear in the
display. Cycle through the different possibilities until
you find the one that matches your set up (or is
closest to it).
Press # to advance to the next receiver setting mode, or
press @ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting
mode.
SUBWOOFER ON/Plus/OFF setting
mode
Set the SUBWOOFER to ON, OFF or Plus.
ON: When you are using a subwoofer .
OFF: When you are not using a subwoofer.
Plus: When a subwoofer is used, you have the option of
selecting the PLS setting, which adds extra bass.
Follow steps 1-3 on page 25 (if necessary).
Press % or fi to select subwoofer ON, Plus or
OFF.
Press # to advance to the next receiver setting mode, or
press @ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting
mode.
MEMO:
• The setting will switch ON or OFF automatically,
depending on whether you have connected a
subwoofer or not.
• Plus is expressed as PLS in the display.
• Setting the front speaker size to “Small” in the
SPEAKERS setting mode automatically locks the
subwoofer in the
ON position.
• There are some cases where no sound will come from
the subwoofer even if it is set to ON (this depends on
the speaker setting, the listening mode and/or the
kind of source material.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer VSX-C300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-C300 in the language / languages: English as an attachment in your email.

The manual is 5,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer VSX-C300

Pioneer VSX-C300 User Manual - English - 1 pages

Pioneer VSX-C300 User Manual - German - 56 pages

Pioneer VSX-C300 User Manual - Dutch - 112 pages

Pioneer VSX-C300 User Manual - French, Italian - 112 pages

Pioneer VSX-C300 User Manual - Portuguese, Swedish - 112 pages

Pioneer VSX-C300 User Manual - Spanish - 112 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info