794003
72
Zoom out
Zoom in
Previous page
1/76
Next page
Additional information12
72
En
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the ADVANCED
SURROUND button, press and hold the
STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the
display, press ‘
ST –
’.
OK?
shows in the display.
4 Press
SOUND RETRIEVER
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory settings.
Switching the speaker
impedance
We recommend using speakers of 8
with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
impedance rating.
With the receiver in standby, press
STANDBY/ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
SP 6 OHM
– Use this setting if your
speakers are rated at 6
.
SP 8 OHM
– Use this setting if your
speakers are rated at 8
or more.
Specifications
Amplifier section
Continuous power output
(stereo)
Front . . .95 W (20 Hz to 20 kHz, THD 0.2 %, 8
)
1
Rated power output
(surround / 20 Hz to 20 kHz, THD 0.06 %, 8
)
Front . . . . . . . . . . . . . . . . . . . . . .95 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 W
Surround. . . . . . . . . . . . . . . . . . .95 W per channel
Rated power output
(surround / 1 kHz, THD 0.05 %, 8
)
Front . . . . . . . . . . . . . . . . . . . . .120 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W
Surround. . . . . . . . . . . . . . . . . .120 W per channel
Audio section
Input (Sensitivity/Impedance)
AUX, CD, CD-R/TAPE/MD, DVD/BD,
TV/SAT, DVR/VCR . . . . . . . . . . . . . .335 mV/47 k
Frequency response
AUX, CD, CD-R/TAPE/MD, DVD/BD,
TV/SAT, DVR/VCR . . . . .5 Hz to 100 000 Hz dB
Output (Level/Impedance)
CD-R/TAPE/MD, DVR/VCR . . . . . . 335 mV/2.2 k
Tone control
Bass . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (100 Hz)
Treble . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (10 kHz)
Loudness . . . . . . +10 dB/+5 dB (100 Hz/10 kHz)
(at volume level –50 dB)
Signal-to-Noise Ratio (IHF, short circuited,
A network)
AUX, CD, CD-R/TAPE/MD, DVD/BD,
TV/SAT, DVR/VCR . . . . . . . . . . . . . . . . . . . . .96 dB
Signal-to Noise Ratio [EIA, at 1 W (1 kHz)]
AUX, CD, CD-R/TAPE/MD, DVD/BD,
TV/SAT, DVR/VCR . . . . . . . . . . . . . . . . . . . . 79 dB
Note
1 Continuous average power output of 95 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than
0.2 %** total harmonic distortion (front).
* Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers.
** Measured by Audio Spectrum Analyzer.
VSX_918_818_KU.book 72 ページ 2007年11月28日 水曜日 午後6時58分
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer VSX-818V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-818V in the language / languages: English as an attachment in your email.

The manual is 1.81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info