574089
29
Zoom out
Zoom in
Previous page
1/78
Next page
The System Setup menu 06
29
En
English
Français
Deutsch
Nederlands
Italiano
Español
Center (C) – Select LARGE if your center
speaker reproduces bass frequencies
effectively, or select SMALL to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect a center
speaker, choose NO (the center channel is
sent to the other speakers).
Surround (S) – Select LARGE if your
surround speakers reproduce bass
frequencies effectively. Select SMALL to
send bass frequencies to the other
speakers or subwoofer. If you didn’t
connect surround speakers choose NO
(the sound of the surround channels is
sent to the other speakers).
Subwoofer (SW) – LFE signals and bass
frequencies of channels set to SMALL are
output from the subwoofer when YES is
selected.
1
Choose the PLUS setting if you
want the subwoofer to output bass sound
continuously or you want deeper bass (the
bass frequencies that would normally
come out the front and center speakers are
also routed to the subwoofer). If you did not
connect a subwoofer choose NO (the bass
is output from other speakers).
Crossover network
•Default setting: 100Hz
This setting decides the cutoff between bass
sounds playing back from the speakers
selected as LARGE, or the subwoofer, and bass
sounds playing back from those selected as
SMALL.
2
It also decides where the cutoff will
be for bass sounds in the LFE channel.
1 Select ‘
X.OVER’
from the SP SETUP
menu.
2Use
/
to choose the frequency cutoff
point.
Frequencies below the cutoff point will be sent
to the subwoofer (or LARGE speakers).
Channel level
Using these settings, you can adjust the
overall balance of your speaker system.
1 Select
CH LEVEL
from the SP SETUP
menu.
2Use
/
to select a setup option.
T. TONE M. – Move the test tone manually
from speaker to speaker and adjust
individual channel levels.
T. TONE A. – Adjust channel levels as the
test tone moves from speaker to speaker
automatically.
3 Confirm your selected setup option.
The test tones will start after you press
ENTER.
3
4
Adjust the level of each channel using
/
.
If you selected T. TONE M., use / to
switch speakers.
The T. TONE A. setup outputs test tones in the
following order (depends on speaker settings):
L
C
R
RS
LS
SW
Adjust the level of each speaker as the test
tone is emitted.
4
Note
1 If you can’t get good bass results, listen to the bass response with the subwoofer set to PLUS and YES or the front speakers
set to LARGE and SMALL alternatively and let your ears judge which sounds best. If you’re having problems, the easiest option
is to route all the bass sounds to the subwoofer by selecting SMALL for the front speakers.
2 For more on selecting the speaker sizes, see Speaker setting above.
3 After the volume increases to the reference level, test tones will be output.
4 If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level
of each speaker to 75 dB SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
• You can change the channel levels at any time by using EFFECT/CH SEL and +/– on the remote control. You can set two
channel levels: one for DVD 5.1 and one for the listening modes.
VSX_517.fm Page 29 Friday, December 1, 2006 2:41 PM
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer VSX-517-K at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-517-K in the language / languages: English, French as an attachment in your email.

The manual is 3,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer VSX-517-K

Pioneer VSX-517-K User Manual - English - 63 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info