612931
14
Zoom out
Zoom in
Previous page
1/26
Next page
14
3.3 Magnet Calibration Using the SGX-CA500
When using both left and right sensors with the SGX-CA500 cycle computer, Magnet Calibration is necessary.
・Magnet Calibration allows the sensors to detect the precise position of the magnet. This is essential for correct display
of the force vectors so please ensure that it is done correctly.
・Magnet Calibration requires the SGX-CA500 cycle computer. It cannot be done with other cycle computers. Also, the
sensors must be in Pedaling Mode.
・The firmware of the SGX-CA500 must be version 20150501.02.43 or higher. If this is not the case, please update the
firmware. Details of how to do this are available on the following website.
http://pioneer-cyclesports.com/jp/support/products/
3.3.1 Preparations
Use a roller or other stand to hold the bicycle upright with the front and back wheels at the same height. Rotate the crank
at least three times to activate the sensors.
3.3.2 Detection of Magnet Position
With the magnets attached temporarily as described in section 3.1Temporarily affix the Magnet, navigate to the Magnet
calibration screen on the SGX-CA500.
[Options] -> [Pedaling Settings] ->[Magnet Calibration]
Rotate the crank slowly at around 30rpm, and check that the count rises once per revolution. If the count does not rise,
check the position of the magnets again. Note! Do not press [Calibration Start] yet!
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer SGY-PM910HR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer SGY-PM910HR in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer SGY-PM910HR

Pioneer SGY-PM910HR User Manual - English, German, Dutch, French, Italian, Spanish - 234 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info