612929
26
Zoom out
Zoom in
Previous page
1/234
Next page
26
EN
Pairing /Calibration
Calibrating the sensors (zero point calibration)
This section describes how to use the Cyclocomputer to calibrate the zero
point of the pedaling monitor sensor that is installed on the bicycle. Zero point
calibration is a function to store the zero point (no-load), where no forces act
on the crank, in the sensor memory. The accuracy of the sensor improves
with repeated implementation.
Zero point calibration should be done by customers whenever the measurement value is
deviating.
The right-side pedaling monitor sensor is used as an example in this description. The
procedure to calibrate the left side is the same as for the right side.
Please do not push the push switch in the right transmitter while calibrating the sensor
with the Cyclocomputer.
Calibration method in pedaling monitor mode using SGX-CA500
Getting Started
1. Stop the bicycle on a at
safe place.
Calibrating the Zero Point
1. Position the crank arm so
it is perpendicular to the
ground, pointing downward.
2. Tap the [Sensors] icon in the
home screen of the SGX-
CA500.
The sensor list screen opens.
3. Tap [Pedaling Monitor R] and
then [Calibration (Zero)].
4. Tap [Start Calibration].
The calibration starts.
If the calibration is successful,
“Success” appears in the [Result] eld.
If “Failure” is displayed, the sensor may
be calibrated in an unstable condition
causing the crank to be moving during
the calibration. Calibrate again with the
crank in a stable position.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer SGY-PM910H2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer SGY-PM910H2 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer SGY-PM910H2

Pioneer SGY-PM910H2 Installation Guide - English - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info