4.
Install the new battery (CR2032).
Right transmitter•
Left transmitter•
Do not use batteries other than •
CR2032.
5.
Check the LED display.
Check the following LEDs to make
sure that they are working properly.
Power meter mode• :
When the batteries are installed, the
left and right transmitters start pairing.
When pairing is nished, the LEDs
on the left and right transmitters light
green for 10 seconds.
Pedaling mode• :
When the batteries are installed, the
LEDs light green for 10 seconds.
If the LEDs do not light, or only one •
side lights, install the batteries again.
If the LEDs still do not light, the battery
may be almost empty. Replace the
battery with a new one.
When you use it in power meter mode, •
insert the right battery and then the
left battery and complete pairing the
left and right sensors within 5 minutes.
6.
Install the cover and tighten
the screws to x it in place.
Use a tool that can measure the torque
to tighten the screws.
Tightening torque: 18 cN·m•
Tighten the screws on the left •
transmitter in a diagonal pattern.
