573930
6
Zoom out
Zoom in
Previous page
1/10
Next page
6
En
Connections and Use
Connection
Before making or changing the
connections, switch off the power and
disconnect the power cord from the AC
outlet.
Connecting the speakers
To get the best out of your speakers it is
important that you connect them properly to
your receiver. Each speaker connection
consists of a positive (+) and a negative (–)
terminal. These should be matched between
the receiver and the speaker.
1 Attach one end of the supplied speaker
cord to the rear of the each speaker.
Connect the wire with the colored
marker to the red (+) terminal; the plain
wire to the black (–) terminal. Press
down the spring-loaded tab and insert
the wire, as shown below. Release the
tab to secure the wire.
2 Connect the other end of each speaker
cord to your receiver.
To connect, insert the colored wire into
the matching positive (colored) terminal
and the other wire into the negative
(black) terminal. See also the Operating
Instructions that came with your
receiver.
These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent the
risk of electric shock when connecting or
disconnecting the speaker cords,
disconnect the power cord before touching
any uninsulated parts.
After connecting the plugs, pull lightly on
the cords to make sure that the ends of the
cords are securely connected to the
terminals. Poor connections can create
noise and interruptions in the sound.
If the cords’ wires happen to be pushed out
of the terminals, allowing the wires to come
into contact with each other, it places an
excessive additional load on the receiver.
This may cause the amp to stop
functioning, and may even damage the
receiver.
When using a set of speakers connected to
an receiver, you won’t be able to obtain the
normal stereo effect if the polarity (+, –) of
one of the speakers (left or right) is
reversed.
Operation
Set the receiver’s cross-over frequency
at 200 Hz.
Red (+)
Black (–)
Red colored marker
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer S-11-P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer S-11-P in the language / languages: English as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info