791722
143
Zoom out
Zoom in
Previous page
1/156
Next page
Additional information 15
143
En
English
Troubleshooting
Incorrect operation is often mistaken for trouble and malfunction. If you think there is something wrong with this
component, please check the points below. Sometimes the trouble may lie in another component. Investigate the
other components and electrical appliances being used. If the trouble cannot be rectified even after checking the
points below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
General
Problem Remedy
The disc is automatically ejected
after closing the disc tray
• Check that the disc is not a DVD+R/RW, DVD-RAM or other incompatible format
disc (page 42).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• Take out the disc and clean it (page 150).
• Check that the disc has a region code compatible with the recorder (page 153).
No picture
• Check that everything is connected properly (page 45).
• Check that the connected TV and/or the AV amp/receiver is set to the correct
input.
• The recorder may be set to progresive scan with an incompatible TV.
Reset to interlace by pressing and holding the front panel
button then pressing
.
Can’t play a disc
• Check that the disc is a compatible format disc (page 42).
• Take out the disc and clean it (page 150).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• There may be condensation in the recorder. Leave the recorder for an hour or so
for the condensation to evaporate.
• During HDD recording, you can’t play discs that are recorded with a Line System
different to the current recorder setting.
Can’t record a disc
• Check that the disc is not a DVD+R/RW, DVD-RAM or other incompatible format
disc (page 42).
All settings are reset
• If the recorder is unplugged (or there is a power failure) while the recorder is on,
all the settings will be lost.
• Make sure that you switch the recorder into standby before unplugging the
power cord.
Remote control does not work
• If you connected this recorder to the receiver subwoofer using the
CONTROL
IN
jack, point the remote control at the display unit of the receiver subwoofer to use
(page 16). Also make sure that the analog audio outputs are connected (directly or
via your TV) to the receiver subwoofer.
• Set the remote control to the same ID number as the recorder (page 136). (When
the batteries run down, the remote mode is automatically reset to
Recorder1
.)
• Use the remote within its operating range (page 16).
• Replace the batteries (page 16).
No sound or sound is distorted
• Make sure that the receiver subwoofer or TV is set to the correct input and the
volume turned up.
• There is no sound when the picture is paused, or during scanning or slow
motion play. Press
to resume regular playback.
• DTS audio can only be played back if the recorder’s digital output is connected
to the receiver subwoofer. If connected to your TV, your TV must have a DTS
decoder for you to be able to enjoy DTS sound.
• Some 96kHz discs do not output audio through the digital jack.
• Check the optical and analog audio cable connections (page 45).
• If the sound is distorted, try cleaning the cable plugs.
DVR-530H_EU.book Page 143 Friday, May 13, 2005 3:11 PM
Downloaded from www.Manualslib.com manuals search engine
143


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer RCS-77H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer RCS-77H in the language / languages: English as an attachment in your email.

The manual is 7.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer RCS-77H

Pioneer RCS-77H User Manual - Dutch - 156 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info