573928
144
Zoom out
Zoom in
Previous page
1/156
Next page
Additional information
17
144
En
Troubleshooting
Incorrect operation is often mistaken for trouble and malfunction. If you think there is something wrong with this
component, please check the points below. Sometimes the trouble may lie in another component. Investigate the
other components and electrical appliances being used. If the trouble cannot be rectified even after checking the
points below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
General
Problem Remedy
The disc is automatically ejected
after closing the disc tray
• Check that the disc is not an incompatible format disc (page 41).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• Take out the disc and clean it (page 152).
• Check that the disc has a region code compatible with the recorder.
Can’t play a disc • Check that the disc is a compatible format disc (page 41).
• Take out the disc and clean it (page 152).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• There may be condensation in the recorder. Leave the recorder for an hour or so for
the condensation to evaporate.
• During HDD recording, you can’t play discs that are recorded with a Line System
different to the current recorder setting.
• DVD+R/+RW discs recorded using another recorder with copy-once protected
recordings will not play in this recorder.
Can’t record a disc • Check that the disc is not an incompatible format disc (page 41).
• Some DVD-RAM discs are not recordable until they have been initialized (page 87).
This can take up to 1 hour.
No picture • Check that everything is connected properly (page 46).
• Check that the connected TV and/or the AV amp/receiver is set to the correct input.
The recorder may be set to progressive scan with an incompatible TV. Reset to
interlace by pressing and holding the front panel STOP button then pressing
ONE TOUCH COPY.
• If you are using an indoor antenna that requires power, make sure that Aerial Power
in the Initial Setup menu is set to On or Auto (page 130).
• If the aerial/antenna is not connected properly, or if it is shorted, the Aerial Power
setting will revert to Off automatically. Check the aerial connection and try making
the setting again.
All settings are reset • If the recorder is unplugged (or there is a power failure) while the recorder is on, all
the settings will be lost.
• Make sure that you switch the recorder into standby before unplugging the power
cord.
Remote control does not work
If you connected this recorder to the receiver subwoofer using the CONTROL IN jack,
point the remote control at the display unit of the receiver subwoofer to use (page 14).
• Set the remote control to the same ID number as the recorder (page 138). (When
the batteries run down, the remote mode is automatically reset to Recorder1.)
• Use the remote within its operating range (page 14).
• Replace the batteries (page 15).
Downloaded from www.Manualslib.com manuals search engine
144


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer RCS-656HX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer RCS-656HX in the language / languages: English as an attachment in your email.

The manual is 6,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer RCS-656HX

Pioneer RCS-656HX User Manual - English - 156 pages

Pioneer RCS-656HX User Manual - Danish - 464 pages

Pioneer RCS-656HX User Manual - French - 155 pages

Pioneer RCS-656HX User Manual - Swedish, Finnish - 464 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info