573927
140
Zoom out
Zoom in
Previous page
1/152
Next page
Additional information
16
140
En
Troubleshooting
Incorrect operation is often mistaken for trouble and malfunction. If you think there is something wrong with this
component, please check the points below. Sometimes the trouble may lie in another component. Investigate the
other components and electrical appliances being used. If the trouble cannot be rectified even after checking the
points below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
General
Problem Remedy
The disc is automatically
ejected after closing the
disc tray
• Check that the disc is not an incompatible format disc (page 45).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• Take out the disc and clean it (page 147).
• Check that the disc has a region code compatible with the recorder.
Can’t play a disc • Check that the disc is a compatible format disc (page 45).
• Take out the disc and clean it (page 147).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• There may be condensation in the recorder. Leave the recorder for an hour or so for the
condensation to evaporate.
• During HDD recording, you can’t play discs that are recorded with a Line System
different to the current recorder setting.
• DVD+R/+RW discs recorded using another recorder with copy-once protected
recordings will not play in this recorder.
Can’t record a disc • Check that the disc is not an incompatible format disc (page 45).
• Some DVD-RAM discs are not recordable until they have been initialized (page 85). This
can take up to 1 hour.
No picture • Check that everything is connected properly (page 50).
• Check that the connected TV and/or the AV amp/receiver is set to the correct input.
• The recorder may be set to progressive scan with an incompatible TV. Reset to interlace
by pressing and holding the front panel STOP button then pressing PLAY.
All settings are reset • If the recorder is unplugged (or there is a power failure) while the recorder is on, all the
settings will be lost.
• Make sure that you switch the recorder into standby before unplugging the power cord.
Remote control does not
work
• If you connected this recorder to the receiver subwoofer using the CONTROL IN jack,
point the remote control at the display unit of the receiver subwoofer to use (page 17).
• Set the remote control to the same ID number as the recorder (page 134). (When the
batteries run down, the remote mode is automatically reset to Recorder1.)
• Use the remote within its operating range (page 17).
• Replace the batteries (page 17).
No sound or sound is dis-
torted
• Make sure that the receiver subwoofer or TV is set to the correct input and the volume
turned up.
• There is no sound when the picture is paused, or during scanning or slow motion play.
Press PLAY to resume regular playback.
• DTS audio can only be played back if the recorder’s digital output is connected to the
receiver subwoofer. If connected to your TV, your TV must have a DTS decoder for you to
be able to enjoy DTS sound.
• Some 96 kHz discs do not output audio through the digital jack.
• Check the audio cable connections (page 50).
• If the sound is distorted, try cleaning the cable plugs.
Cannot switch a bilingual
program
• During real-time copying it is not possible to switch audio channels. The main and sub
channels are both output.
140


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer RCS-606H-S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer RCS-606H-S in the language / languages: English as an attachment in your email.

The manual is 5,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer RCS-606H-S

Pioneer RCS-606H-S User Manual - German - 156 pages

Pioneer RCS-606H-S User Manual - Dutch - 152 pages

Pioneer RCS-606H-S User Manual - French - 152 pages

Pioneer RCS-606H-S User Manual - Italian - 152 pages

Pioneer RCS-606H-S User Manual - Swedish - 298 pages

Pioneer RCS-606H-S User Manual - Spanish - 152 pages

Pioneer RCS-606H-S User Manual - Norwegian - 298 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info