Manual Pioneer DEH-X7500SD (page 3 of 32) (English, German, Dutch, French, Italian, Spanish)

525991

Zoom out

Zoom in

1/32

Important

! When installing this unit in a vehicle without

an ACC (accessor y) position on the ignition

switch, failure to connect the red cable to the

terminal that detects operation of the ignition

key may result in battery drain.

ACC position No ACC position

! Use of this unit in conditions other than the

following could result in fire or malfunction.

— Vehicles with a 12-volt battery and negative

grounding.

— Speakers with 50 W (output value) and 4W to

8 W (impedance value).

! To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

— Disconnect the negative terminal of the bat-

tery before installation.

— Secure the wiring with cable clamps or adhe-

sive tape. Wrap adhesive tape around wiring

that comes into contact with metal parts to

protect the wiring.

— Place all cables away from moving parts,

such as the shift lever and seat rails.

— Place all cables away from hot places, such

as near the heater outlet.

— Do not connect the yellow cable to the batter y

by passing it through the hole to the engine

compartment.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable of

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

— Never wire the negative speaker cable directly

to ground.

— Never band together negative cables of multi-

ple speakers.

! When this unit is on, control signals are sent

through the blue/white cable. Connect this

cable to the system remote control of an ex-

ternal power amp or the vehicle’s auto-anten-

na relay control terminal (max. 300 mA

12 V DC). If the vehicle is equipped with a

glass antenna, connect it to the antenna

booster power supply terminal.

! Never connect the blue/white cable to the

power terminal of an external power amp.

Also, never connect it to the power terminal

of the auto antenna. Doing so may result in

battery drain or a malfunction.

! The black cable is ground. Ground cables for

this unit and other equipment (especially,

high-current products such as power amps)

must be wired separately. If they are not, an

accidental detachment may result in a fire or

malfunction.

This unit

3 5 6a7 b

1 USB port 1

2 USB port 2 (DEH-X8500DAB and DEH-

X8500BT only)

3 Antenna input

15 cm

4 DAB antenna input (DEH-X8500DAB only)

To receive DAB signals, connect a DAB an-

tenna (AN-DAB1) sold separately to the unit.

5 Fuse (10 A)

6 Power cord input

7 Wired remote input

Hard-wired remote control adapter can be

connected (sold separately).

8 Microphone input (DEH-X8500DAB and

DEH-X8500BT only)

9 Microphone (DEH-X8500DAB and DEH-

X8500BT only)

a Rear output

b Front output

c Subwoofer output

d USB cable

1.5 m

! Only for DEH-X8500DAB and DEH-X8500BT

If connecting both USB1 (USB storage

device1)/iPod1 (iPod connected using

USB input1) and USB2 (USB storage de-

vice2)/iPod2 (iPod connected using USB

input2) at the same time, use a Pioneer

USB cable (CD-U50E) in addition to the

regular Pioneer USB cable.

Power cord

1 To power cord input

2 Depending on the kind of vehicle, the func-

tion of 3 and 5 may be different. In this

case, be sure to connect 4 to 5 and 6 to

3 Yellow

Back-up (or accessory)

4 Yellow

Connect to the constant 12 V supply termi-

nal.

5 Red

Accessory (or back-up)

6 Red

Connect to terminal controlled by ignition

switch (12 V DC).

7 Connect leads of the same color to each

other.

8 Orange/white

Connect to lighting switch terminal.

9 Black (chassis ground)

English

Connections

Section

Connections

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer DEH-X7500SD in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,45 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer DEH-X7500SD

Pioneer DEH-X7500SD User Manual - English - 44 pages

Pioneer DEH-X7500SD User Manual - German - 52 pages

Pioneer DEH-X7500SD User Manual - Dutch - 48 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Pioneer DEH-X7500SD Manual

Product: