Audio Adjustments
Each press of 5 or ∞ increases or decreases
the treble level. +6 – –6 is displayed as the level
is increased or decreased.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Loud.
Press AUDIO until Loud appears in the display.
3 Press 5 to turn loudness on.
Loudness level (e.g., Loud Mid) appears in the
display.
4 Press 2 or 3 to select the level.
Press 2 or 3 until the desired level appears in
the display.
Low (low)—Mid (mid)—High (high)
5 Press ∞ to turn loudness off.
Loud OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press
OPEN to open the front panel.
2 Press AUDIO to select Sub-W1.
When the Subwoofer Controller setting is
S.W
Control:EXT, you can select Sub-W1. Press
AUDIO until Sub-W1 appears in the display.
3 Press 5 to turn subwoofer output on.
Sub-W1 Normal appears in the display.
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
∞.
4 Press 2 or 3 to select the phase of sub-
woofer output.
Press 2 to select reverse phase and Rev.
appears in the display. Press 3 to select normal
phase and Normal appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press
OPEN to open the front panel.
2 Press AUDIO
to select Sub-W2.
When the subwoofer output is on, you can
select
Sub-W2. Press AUDIO until Sub-W2 80
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as 50 (Hz) or 125
(Hz).
3 Press 2 or 3 to select cut-off frequency.
Press 2 or 3 until the desired cut-off frequency
appears in the display.
50—80—125 (Hz)
• Only frequencies lower than those in the
selected range are output from the subwoofer.
4 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer. +6 – –6 is displayed
as the level is increased or decreased.
Press 5 or ∞ until you see the desired value
displayed.
En
46
08
Section
