Audio-instellingen
Du
39
Aanpassen van de subwoofer
instellingen
Wanneer het uitgangssignaal voor de
subwoofer is ingeschakeld, kunt u ook de
instelling voor de subwoofer selecteren.
1 Druk op AUDIO en selecteer Sub-W2.
Wanneer de subwooferuitgang is ingeschakeld,
kunt u Sub-W2 selecteren. Druk op AUDIO tot
Sub-W2 80 (Hz) op het display verschijnt.
• Als de instelling voor de subwoofer eerder
werd aangepast, zal de eerder aangepaste
frequentie op het display verschijnen,
bijvoorbeeld 50 (Hz) of 125 (Hz).
2Druk op 2 of 3 om de drempel-frequentie
te kiezen.
Druk op 2 en 50 (Hz) zal op het display
verschijnen. Druk op 3 en 125 (Hz) zal op het
display verschijnen. Alleen frequenties beneden
de gekozen frequentie zullen door de subwoofer
worden weergegeven.
3druk op 5 of ∞ om het uitgangsniveau van
de subwoofer in te stellen.
Met elke druk op 5 of ∞ zal het niveau van de
subwoofer worden verhoogd respectievelijk
verlaagd (bijv. tussen +6 t/m –6).
Druk op 5 of ∞ tot u de gewenste waarde op het
display ziet verschijnen.
Gebruik van een uitgangssignaal
zonder fade
Wanneer de functie voor uitgangssignalen zonder
fade (Non Fading Output instelling ON) aan
staat, gaat het audiosignaal niet door het Low-
pass filter van dit toestel (voor de Subwoofer),
maar wordt direct via de RCA aansluiting
(tulpstekker) naar buiten gebracht.
1 Druk op
AUDIO
en selecteer de aan/uit-
functie voor uitgangssignalen zonder fade.
Wanneer de subwoofer-bedieningsfunctie is
ingesteld op
S.W Control:EXT, kunt u de aan/uit-
functie voor uitgangssignalen zonder fade
selecteren. Druk op AUDIO tot NonFad ON op
het display verschijnt.
2 Druk op 5 om de functie voor
uitgangssignalen zonder fade in te schakelen.
NonFad ON verschijnt op het display en de
functie voor uitgangssignalen zonder fade is
ingeschakeld.
• Druk op ∞ om de functie voor
uitgangssignalen zonder fade weer uit te
schakelen.
Instellen van het niveau van het
uitgangssignaal zonder fade
Wanneer de functie voor uitgangssignalen
zonder fade is ingeschakeld, kunt u het
uitgangsniveau van het signaal instellen.
1 Druk op
AUDIO en selecteer de
instellingsfunctie voor uitgangssignalen
zonder fade.
Druk op AUDIO tot NonFad 0 op het display
verschijnt.
2 Druk op 5 of ∞ om het uitgangsniveau van
het signaal zonder fade in te stellen.
Bij elke druk op 5 of ∞ wordt het niveau van het
signaal verhoogd of verlaagd (van
+6 tot –6).
Druk op 5 of ∞ tot de gewenste waarde op het
display wordt aangegeven.
English
Español
Deutsch
Français
Italiano
Nederlands
08
Hoofdstuk