45506
5
Zoom out
Zoom in
Previous page
1/8
Next page
Note:
When this unit is installed in a vehicle without
ACC (accessory) position on the ignition switch,
red cable must be wired to the terminal that can
detect the operation of the ignition key.
Otherwise, battery drain may result.
Use this unit in other than the following condi-
tions could result in fire or malfunction.
Vehicles with a 12-volt battery and negative
grounding.
Speakers with 50 W (output value) and 4 ohm
to 8 ohm (impedance value).
To prevent short-circuit, overheating or malfunc-
tion, be sure to follow the directions below.
Disconnect the negative terminal of the bat-
tery before installation.
Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap adhe-
sive tape around them where they lie against
metal parts.
Place all cables away from moving parts,
such as gear shift and seat rails.
Place all cables away from hot places, such as
near the heater outlet.
Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
Cover any disconnected cable connectors
with insulating tape.
Do not shorten any cables.
Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
Use a fuse of the rating prescribed.
Never wire the speaker negative cable directly
to ground.
Never band together multiple speaker’s nega-
tive cables.
Control signal is output through blue/white cable
when this unit is powered on. Connect it to an
external power amp’s system remote control or
the vehicle’s auto-antenna relay control terminal
(max. 300 mA, 12 V DC). If the vehicle is
equipped with a glass antenna, connect it to the
antenna booster power supply terminal.
Never connect blue/white cable to external power
amp’s power terminal. Also, never connect it to
the power terminal of the auto antenna.
Otherwise, battery drain or malfunction may
result.
IP-BUS connectors are color-coded. Be sure to
connect connectors of the same color.
Black cable is ground. This cable and other prod-
uct’s ground cable (especially, high-current prod-
ucts such as power amp) must be wired separate-
ly. Otherwise, fire or malfunction may result if
they are accidentally detached.
Cord function may differ according to the
product, even if cord color is the same. When
connecting this system, be sure to check all
manuals and connect cords correctly.
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
++
++
++
33. Power amp
(sold separately)
39. Subwoofer
1*
3* 2*
4*5*
17.
N
ote
:
D
e
p
en
di
n
g
on t
h
e
ki
n
d
o
f
ve
hi
c
l
e,
the function of 3* and 5* ma
be
diff
erent. In t
hi
s case,
b
e sure to
connect 2* to
5
* and 4* to
3
*.
18. Connect leads of the same
color to each other.
19. Cap (1*)
Do not remove cap
if this terminal is
not in use.
20. Yellow (3*)
Back-up (or
accessory)
22. Red (5*)
Accessory
(or back-up)
21. Yellow (2*)
Connect to the constant
12 V supply terminal.
23. Red (4*)
Connect to terminal controlled
by ignition switch (12 V DC).
24. Orange/white
Connect to lighting switch terminal.
2
6
.I
SO
connector
N
ote
:
In some vehicles, the ISO connector ma
y
b
e
di
v
id
e
d
i
nto two. In t
hi
s case,
b
e sure
to connect to
b
ot
h
connectors.
31. Speaker leads
White: Front left +
White/black: Front left
Gray: Front right +
Gray/black: Front right
Green: Rear left +
o
r
subwoofe
r
+
Green/black: Rear left or subwoofer
Violet: Rear right + or subwoofer +
Violet/black: Rear right or subwoofer
32. Connect with RCA cables
(sold separately)
28. Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
29. Blue/white (7*)
Connect to auto-antenna relay control
terminal (max. 300 mA 12 V DC).
The pin position of the ISO connector will
differ depends on the type of vehicle. Connect
6* and 7* when Pin 5 is an antenna control
type. In another type of vehicle, never connect
6* and 7*.
38. Rear speaker
40. Perform these connections when
using the optional amplifier.
41.
N
otes
:
C
han
g
e the initial settin
g
of this unit (refer to the O
p
eration
M
anua
l
). T
h
e su
b
woo
f
er out
p
ut o
f
t
hi
s un
i
t
i
s monaura
l
.
When using a subwoofer of 70 W (2 ) , be sure to connect
with Violet and Violet/black leads of this unit. Do not connect
anything with Green and Green/black leads.
27. Yellow/black
If you use an equipment with Mute
function, wire this lead to the Audio
Mute lead on that equipment. If not,
keep the Audio Mute lead free of any
connections.
U
se a stereo m
i
n
i
pl
u
g
ca
ble
to connect w
i
t
h
aux
ili
ar
y
e
q
u
ip
ment.
25. Black (chassis ground)
Connect to a clean, paint-free metal location.
1. iPod with Dock
Connector
3. Dock connector port
2. Dock connector
4. Interface cable (e.g., CD-I200)
(sold separately)
2 m
6. This product
7. Rear output
8. Front output
9. Antenna jack
10. Subwoofer output
11. Fuse (10 A)
12. AUX jack (3.5 ø)
1
3
.
Wi
re
d
remote
i
n
p
u
t
H
ar
d
-
wi
re
d
remote contro
l
a
d
a
p
tor can
b
e connecte
d
(
so
ld
se
p
arate
ly
).
14. IP-B
US
i
n
p
ut (B
l
ue
)
15. IP-BUS cable
1
6
. Mu
l
t
i
-CD
pl
a
y
er
(sold separately)
33. Power amp
(sold separately)
33. Power amp
(sold separately)
34. System remote control
30. Blue/white (6*)
35. Front speaker 35. Front speaker
36. Left
37. Right
38. Rear speaker
39. Subwoofer
15 cm
5. Gray
Connecting the Units
ENGLISH
Connection Diagram
1. iPod with Dock Connector
2. Dock connector
3. Dock connector port
4. Interface cable (e.g., CD-I200) (sold separately)
5. Gray
6. This product
7. Rear output
8. Front output
9. Antenna jack
10. Subwoofer output
11. Fuse (10 A)
12. AUX jack (3.5 ø)
Use a stereo mini plug cable to connect with
auxiliary equipment.
13. Wired remote input
Hard-wired remote control adaptor can be con-
nected (sold separately).
14. IP-BUS input (Blue)
15. IP-BUS cable
16. Multi-CD player (sold separately)
17. Note:
Depending on the kind of vehicle, the function of
3* and 5* may be different. In this case, be sure
to connect 2* to 5* and 4* to 3*.
18. Connect leads of the same color to each other.
19. Cap (1*)
Do not remove cap if this terminal is not in use.
20. Yellow (3*)
Back-up (or accessory)
21. Yellow (2*)
Connect to the constant 12 V supply terminal.
22. Red (5*)
Accessory (or back-up)
23. Red (4*)
Connect to terminal controlled by ignition switch
(12 V DC).
24. Orange/white
Connect to lighting switch terminal.
25. Black (chassis ground)
Connect to a clean, paint-free metal location.
26. ISO connector
Note:
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to connect
to both connectors.
27. Yellow/black
If you use an equipment with Mute function,
wire this lead to the Audio Mute lead on that
equipment. If not, keep the Audio Mute lead free
of any connections.
28. Blue/white
Connect to system control terminal of the power
amp (max. 300 mA 12 V DC).
29. Blue/white (7*)
Connect to auto-antenna relay control terminal
(max. 300 mA 12 V DC).
30. Blue/white (6*)
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and
7* when Pin 5 is an antenna control type. In
another type of vehicle, never connect 6* and 7*.
31. Speaker leads
White: Front left
+
White/black: Front left
Gray: Front right +
Gray/black: Front right
Green: Rear left + or subwoofer +
Green/black: Rear left or subwoofer
Violet: Rear right + or subwoofer +
Violet/black: Rear right or subwoofer
32. Connect with RCA cables (sold separately)
33. Power amp (sold separately)
34. System remote control
35. Front Speaker
36. Left
37. Right
38. Rear Speaker
39. Subwoofer
40. Perform these connections when using the
optional amplifier.
41. Notes:
Change the initial setting of this unit (refer to
the Operation Manual). The subwoofer output
of this unit is monaural.
When using a subwoofer of 70 W (2 ), be
sure to connect with Violet and Violet/black
leads of this unit. Do not connect anything with
Green and Green/black leads.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer DEH-P6900IB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer DEH-P6900IB in the language / languages: English, Dutch, French, Spanish as an attachment in your email.

The manual is 1,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer DEH-P6900IB

Pioneer DEH-P6900IB User Manual - German - 137 pages

Pioneer DEH-P6900IB User Manual - Dutch - 134 pages

Pioneer DEH-P6900IB User Manual - French - 137 pages

Pioneer DEH-P6900IB User Manual - Italian - 134 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info