32
Part names and functions
32
6 MASTER 1 output terminals
Connect a powered speaker, a power amp, etc.
!
Compatible with XLR connector type balanced outputs.
Be sure to use these as balanced outputs.
!
Be careful not to accidentally insert the power cord of another unit.
!
Do not connect a terminal that can supply phantom power.
7 LINE/PHONO input terminals
Connect a phono level (for MM cartridges) output device (analog player,
etc.) or a line level output device (DJ player, etc.). Switch the input source
according to the connected device using the [LINE/PHONO] switch on the
rear panel of this unit.
!
The [PHONO/LINE, DECK3, DECK1] selector switch or [DECK2,
DECK4, PHONO/LINE] selector switch on top of the unit needs to be set
to [PHONO/LINE].
8 LINE/PHONO switches
Selects the input source for each channel from the components connected to
this unit.
!
[LINE]: Uses a line level output device (DJ player, etc.) connected to the
[LINE/PHONO] input terminals.
!
[PHONO]: Uses a phono level (for MM cartridges) output device (analog
player, etc.) connected to the [LINE/PHONO] input terminals.
9 SIGNAL GND terminal
Connect a ground wire of an analog player to reduce noise that occurs when
an analog player is connected.
a MIC attenuator
Adjusts the level of the audio input to the [MIC] terminals.
!
The gain of the audio input to the microphone differs greatly depending
on the microphone being used. The [MIC ATT.] control on the rear panel
of the unit is used to adjust the audio level according to the microphone
before DJ performances. During DJ performances, use the [MIC LEVEL]
control on the top of this unit to adjust the volume of the microphone.