811537
137
Zoom out
Zoom in
Previous page
1/177
Next page
English
- 137 -
CAUTION
Thoroughly check the conditions before performing Auto EQ as the speakers may be damaged if this
is performed under the following conditions:
When the speakers are incorrectly connected. (For example, when a rear speaker is connected as a
subwoofer output.)
When a speaker is connected to a power amp delivering output higher than the speaker’s
maximum input power capability.
If a microphone for acoustical measurement (sold separately) is not placed in the appropriate
location, the measurement tone may become loud and measurement may take a long time, resulting
in battery drainage. Be sure to place the microphone in the specified location.
Before operating the Auto EQ function
Perform Auto EQ in a quiet place with the vehicle engine and air conditioning
switched off. Also, cut the power of car phones or mobile phones in the vehicle, or
remove them in advance. Surrounding sounds may prevent correct measurement of
the vehicle’s acoustics.
Be sure to use the microphone for acoustical measurement (sold separately). Using
other microphones may prevent measurement, or result in incorrect measurement of
the vehicle’s acoustics.
To perform Auto EQ, the front speakers must be connected.
When this product is connected to a power amp with input level control, Auto EQ may
be impossible if the power amp’s input level is set below the standard level.
When this product is connected to a power amp with an LPF (low pass filter), turn the
LPF off before performing Auto EQ. Also, set the cutoff frequency for the built-in LPF of
an active subwoofer to the highest frequency.
The distance has been calculated by a computer to provide optimum delay to ensure
accurate results. Do not change this value.
The reflected sound within the vehicle is strong and delay occurs.
The LPF on active subwoofers or external amps delay the lower sounds.
If an error occurs during measurement, check the following before measuring the
vehicle’s acoustics.
Front speakers (left/right)
Rear speakers (left/right)
–Noise
Microphone for acoustical measurement (sold separately)
–Low battery
Performing Auto EQ
CAUTION
Do not turn off the engine while the measurement is in progress.
NOTES
Auto EQ changes the audio settings as follows:
The fader/balance settings return to the centre position (page 133).
Previous settings for Auto EQ will be overwritten.
137


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer AVIC-Z6330BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer AVIC-Z6330BT in the language / languages: English as an attachment in your email.

The manual is 3.08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer AVIC-Z6330BT

Pioneer AVIC-Z6330BT User Manual - German - 196 pages

Pioneer AVIC-Z6330BT User Manual - Dutch - 189 pages

Pioneer AVIC-Z6330BT User Manual - French - 192 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info