699599
9
Zoom out
Zoom in
Previous page
1/76
Next page
9En
English
DAB aerial and its lead (AVIC-Z920DAB/
AVIC-Z820DAB/AVIC-Z720DAB/AVIC-
Z7210DAB)
GPS aerial and its lead
In addition, you should lay or route each
aerial lead as far as possible from other
aerial leads. Do not bind, lay or route them
together, or cross them. Electromagnetic
noise will increase the potential for errors
in the vehicles location display.
Consult with your nearest dealer if
installation requires drilling holes or
other modifications of the vehicle.
Before making a final installation of this
product, temporarily connect the wiring
to confirm that the connections are
correct and the system works properly.
Do not install this product in a position
where the opening of the LCD panel is
obstructed by any obstacles, such as the
gearstick. Before installing this product, be
sure to leave sufficient space so that the
LCD panel does not obstruct the gearstick
when it is fully opened. This may cause
interference with the gearstick, or a
malfunction of the mechanism of this
product.
Do not install this product in places
subject to high temperatures or
humidity, such as:
Places close to a heater, vent or air
conditioner.
Places exposed to direct sunlight, such
as on top of the dashboard.
Places that may be exposed to rain,
such as close to the door or on the
vehicle’s floor.
Install this product in an area strong
enough to bear its weight. Choose a
position where this product can be firmly
installed, and install it securely. If this
product is not securely installed, the
current location of the vehicle cannot be
displayed correctly.
Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with the
surface tilted more than these tolerances
increases the potential for errors in the
vehicle’s location display, and might
otherwise cause reduced display
performance.
When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation
mechanism to dissipate heat.
Before installing
For AVIC-Z920DAB and AVIC-
Z820DAB users
Installation notes
Leave ample
space
5 cm
5 cm
Do not cover this area.
The semiconductor laser will be damaged
if it overheats, so don’t install this product
anywhere hot- for instance, near a heater
outlet.
1 Remove the trim ring.
Extend top and bottom of the trim ring
outwards to remove the trim ring.
Trim ring
2 Insert the supplied extraction keys
into both sides of the unit until they
click into place.
3 Pull the unit out of the holder.
Extraction key
1 Install the holder into the dashboard.
2 Secure the mounting sleeve by using a
screwdriver to bend the metal tabs
(90°) into place.
Dashboard
Holder
3 Install this product into the holder.
Dashboard
4 Attach the trim ring.
Trim ring
Before installing this
product
Installation with the
holder
112 mm
182 mm
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer AVIC-Z6210BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer AVIC-Z6210BT in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer AVIC-Z6210BT

Pioneer AVIC-Z6210BT User Manual - English - 176 pages

Pioneer AVIC-Z6210BT User Manual - German - 196 pages

Pioneer AVIC-Z6210BT User Manual - Dutch - 190 pages

Pioneer AVIC-Z6210BT User Manual - French - 192 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info