162122
6
Zoom out
Zoom in
Previous page
1/181
Next page
5
Connecting the System
Before installing the unit
This unit is for vehicles with a 12-volt battery and negative earthing. Check the battery
voltage of your vehicle before installation.
To prevent damage
When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.
This unit cannot be installed in a vehicle that does not have an ACC (accessory) position
on the ignition switch.
To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especial-
ly important to insulate all unused speaker leads, which if left uncovered may cause a
short circuit.
Attach the connectors of the same colour to the corresponding coloured port, i.e., blue
connector to the blue port, black to black, etc.
The black lead is earth. Please earth this lead separately from the earth of high-current
products such as power amps.
Do not earth more than one product together with the earth from another product. For
example, you must separately earth any amplifier unit away from the earth of the Hide-
away unit. Connecting earths together can cause a fire and/or damage the products if
their earths became detached.
Refer to the owner’s manual for details on connecting the power amp and other units,
then make connections accordingly.
When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse
holder.
Since a unique BPTL circuit is employed, do not directly earth the side of the speaker
lead or connect the sides of the speaker leads together. Be sure to connect the side
of the speaker lead to the side of the speaker lead on the display unit.
If the RCA pin jack on the unit will not be used, do not remove the caps attached to the
end of the connector.
When the auto aerial function is used by connecting the blue lead to the vehicle
with the auto aerial function, either turning off the ignition switch or detaching
the front panel will retract the auto aerial of the vehicle.
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
To avoid shorts in the electrical sys-
tem, be sure to disconnect the (–)
battery cable before beginning
installation.
ENG/MASTER 96
<CRD3958A/U> 6
CRD3958A_U_inst001_031_UK 11/12/04 13:09 Page 6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer avic-x1r at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer avic-x1r in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer avic-x1r

Pioneer avic-x1r User Manual - English - 27 pages

Pioneer avic-x1r User Manual - German - 32 pages

Pioneer avic-x1r User Manual - Dutch - 32 pages

Pioneer avic-x1r User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info