162564
109
Zoom out
Zoom in
Previous page
1/125
Next page
107
AppendixNAVI/AV
Your vehicle is operating in Simple
hybrid mode.
Connect the speed signal input (pink
lead wire) of the power cable cor-
rectly, and reset the 3D Hybrid Sen-
sor (“Learning Status”).
The navigation unit is installed with
an extreme angle exceeding the limi-
tation of the installation angle.
Confirm the installation angle. (This
unit must be installed within +30
degrees to –30 degrees of the hori-
zontal, or within five degrees of your
vehicle’s direction of travel.)
Indication of the position of your
vehicle is misaligned after a U-turn or
reversing.
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The Navigation Sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
The map continually reorients itself. The travelling direction is always set
to north.
Touch on the screen and change
the map display.
Tracking marks are not displayed. The “Tracking Display” is turned
off.
Check the “Tracking Display” set-
tings (
Page 54) and make sure
Always” or “This Trip” is selected.
The daylight display is used even
when the vehicle lights are on.
Daytime is selected on “Day/Night
Display”.
Check the “Day/Night Display” set-
ting (
Page 54) and make sure
Illuminated” is selected.
The Orange/white lead is not con-
nected.
Check the connection.
The system will not switch on or will
not operate.
Installation or connection has been
carried out incorrectly.
Check with your dealer.
The display is very dim. The vehicle’s light is turned ON, and
Illuminated” is selected on “Day/
Night Display”.
Read about the “Day/Night Dis-
play” setting (
Page 54) and, if
desired, select “Daytime”.
The vehicle cabin temperature is
extremely low.
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Picture quality adjustment of the dis-
play is not correct.
Refer to “Hardware Manual” to
adjust the picture quality.
Ambient light sensor of the display is
hidden.
Set the ambient light sensor not to
be hidden.
There is no voice guidance or the vol-
ume is low.
The volume setting is low or the
speaker lead is disconnected.
Check the volume setting on the dis-
play or turn the volume up according
to “Hardware Volume” (
Page 54)
and/or turn up the volume on the dis-
play.
Does not switch to Vehicle Dynam-
ics.
The navigation unit sensor does not
begin working immediately after the
navigation unit is installed on the
vehicle.
Drive for a little while.
Slope is not displayed on the
Vehicle Dynamics screen.
Inclination does not move on the
3D Calibration Status screen.
The speed pulse lead is not con-
nected.
Connect the speed pulse lead.
Symptom Cause Action (See)
109


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer avic x 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer avic x 1 in the language / languages: English as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer avic x 1

Pioneer avic x 1 User Manual - English - 30 pages

Pioneer avic x 1 Installation Guide - English - 181 pages

Pioneer avic x 1 User Manual - German - 139 pages

Pioneer avic x 1 User Manual - German - 32 pages

Pioneer avic x 1 Installation Guide - German - 181 pages

Pioneer avic x 1 User Manual - Dutch - 32 pages

Pioneer avic x 1 Installation Guide - Dutch - 181 pages

Pioneer avic x 1 Quick start guide - Dutch - 2 pages

Pioneer avic x 1 User Manual - French - 138 pages

Pioneer avic x 1 User Manual - French - 32 pages

Pioneer avic x 1 Installation Guide - French, Italian, Spanish - 181 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info