Manual Pioneer AVIC-F860BT (page 158 of 216) (English)

576394

158

Zoom out

Zoom in

1/216

— When a speaker is connected to a power

amp delivering output higher than the

speaker’s maximum input power capabil-

ity.

! If a microphone for acoustical measurement

(sold separately) is not placed in an appropri-

ate location, the measurement tone may be-

come loud and measurement may take a long

time, resulting in battery drainage. Be sure to

place the microphone in the specified loca-

tion.

Before operating the Auto EQ

function

! Perform Auto EQ in as quiet a place as pos-

sible, with the vehicle engine and air condi-

tioning switched off. Also, cut power to car

phones or mobile phones in the vehicle, or

remove them from the vehicle before per-

forming Auto EQ. Sounds other than the

measurement tone (surrounding sounds,

engine sound, telephones ringing, etc.)

may prevent correct measurement of the

vehicle’s acoustics.

! Be sure to perform Auto EQ using the mi-

crophone for acoustical measurement

(sold separately). Using another micro-

phone may prevent measurement, or result

in incorrect measurement of the vehicle’s

acoustics.

! To perform Auto EQ, the front speakers

must be connected.

! When this product is connected to a power

amp with input level control, Auto EQ may

be impossible if the power amp’s input

level is set below the standard level.

! When this product is connected to a power

amp with an LPF (low pass filter), turn the

LPF off before performing Auto EQ. Also,

set the cut-off frequency for the built-in LPF

of an active subwoofer to the highest fre-

quency.

! The distance has been calculated by a

computer to provide optimum delay to en-

sure accurate results. Do not change this

value.

— The reflected sound within the vehicle is

strong and delays occur.

— The LPF on active subwoofers or exter-

nal amps delay the lower sounds.

! If an error occurs during measurement, a

message appears and measurement is

cancelled. Check the following before mea-

suring the vehicle’s acoustics.

— Front speakers (left/right)

— Rear speakers (lef t/right)

— Noise

— Microphone for acoustical measure-

ment (sold separately)

— Low battery

Performing Auto EQ

p Auto EQ changes the audio settings as fol-

lows:

—“Auto EQ&TA” is set to “On”.

= For details, refer to Using the auto-ad-

justed equaliser on page 157.

— The fader/balance settings return to the

centre position.

= For details, refer to Using balance ad-

justment on page 149.

— The equaliser curve switches to “Flat”.

= For details, refer to Using the equali-

ser on page 156.

— The front and rear speakers will automa-

tically be adjusted to a high pass filter

setting.

p Previous settings for Auto EQ will be over-

written.

p For AVIC-F60DAB users

Do not press the h button to open or close

the panel when you are using the micro-

phone.

CAUTION

Do not turn off the engine while the measure-

ment is in progress.

Engb

158

Chapter

Audio adjustments

Could anyone supply a copy of the internal SD card for an AVIC F860BT - My SD card has become corrupted and the unit keeps resetting? Submitted on 16-1-2020 at 23:33
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer AVIC-F860BT in the language / languages: English as an attachment in your email.

The manual is 10,35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer AVIC-F860BT

Pioneer AVIC-F860BT Quick start guide - English - 4 pages

Pioneer AVIC-F860BT User Manual - German - 244 pages

Pioneer AVIC-F860BT Quick start guide - German, Dutch - 4 pages

Pioneer AVIC-F860BT User Manual - Dutch - 232 pages

Pioneer AVIC-F860BT User Manual - French - 240 pages

Pioneer AVIC-F860BT Quick start guide - French - 4 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Pioneer AVIC-F860BT Manual

Product: