649358
2
Zoom out
Zoom in
Previous page
1/8
Next page
Parking brake
switch
Power supply side
Ground side
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of the parking
brake switch.
Yellow/black
If you use equipment with Mute function, wire this lead to
the Audio Mute lead on that piece of equipment. If not, keep
the Audio Mute lead free of any connections.
Connect leads of the same
color to each other.
Cap (1*)
When not using this terminal,
do not remove the cap.
ISO connector
Fuse (10 A)
1*
2*
4*
3*
5*
Yellow (2*)
To terminal always supplied
with power regardless of
ignition switch position.
Red (4*)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Yellow (3*)
Back-up
(or accessory)
Red (5*)
Accessory
(or back-up)
Orange/white
To lighting switch terminal
Black (ground)
To vehicle (metal) body.
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
Fuse resistor
Blue/white (7*)
To Auto-antenna relay control terminal
(max. 300 mA 12 V DC).
Blue/white (6*)
Blue/white
To system control terminal of the power amp
(max. 300 mA 12 V DC).
Speaker leads
White: Front left +
White/black: Front left
Gray: Front right +
Gray/black: Front right
Green: Rear left + or Subwoofer +
Green/black: Rear left or Subwoofer
Violet: Rear right + or Subwoofer +
Violet/black: Rear right or Subwoofer
When you connect the separately sold multi-channel
processor (DEQ-P6600) to this unit, do not
connect anything to the speaker leads and system
remote control (blue/white).
The pin position of the ISO connector will differ
depending on the type of vehicle. Connect 6* and
7* when Pin 5 is an antenna control type. In
another type of vehicle, never connect 6* and 7*.
Note:
Depending on the kind of vehicle, the
function of 3* and 5* may be different.
In this case, be sure to connect 2* to 5*
and 4* to 3*.
Note:
The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner’s Manual or dealer.
Connection method
Clamp the lead.1. 2. Clamp firmly with
needle-nosed
pliers.
IP-BUS cable
This product
Antenna cable
15 cm
16 cm
IP-BUS input
Violet/white
Refer to Fig. 4.
Blue
Multi-CD player
(sold separately)
AUX input jack
20 cm
Rear output
(REAR OUTPUT)
This product
When you connect the separately sold
multi-channel processor (e.g. DEQ-P6600)
to this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
Note :
Change the initial setting of this product
(refer to the Operation Manual).
The subwoofer output of this unit is monaural.
Note :
When you connect the multi-channel processor
to this unit, a separately sold power amp must
be connected to the multi-channel processor.
Front output
(FRONT OUTPUT)
Subwoofer output
or non fading output
(SUBWOOFER OUTPUT or
NON-FADING OUTPUT)
Blue/white
To system control terminal of the power am
p
(max. 300 mA 12 V DC).
+
+
+
+
+
+
Perform these connections when using the
optional amplifier.
Blue/white
Connecting cords
with RCA pin plugs
(sold separately)
System remote control
Rear speaker
Subwoofer Subwoofer
Rear speaker
Front speaker
Front speaker
Left Right
Power amp
(sold separately)
Power amp
(sold separately)
Power amp
(sold separately)
23cm
15cm
15cm
Connecting the power cord
Fig. 2
When connecting to separately sold power amp
Fig. 3
Connecting the Units <ENGLISH>
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer AVH-P6000DVD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer AVH-P6000DVD in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer AVH-P6000DVD

Pioneer AVH-P6000DVD User Manual - English - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info