162112
16
Zoom out
Zoom in
Previous page
1/170
Next page
Installation
En
15
<CRD3863-A> 16
To guard against electromagnetic
interference
In order to prevent interference, set the fol-
lowing items as far as possible from the main
unit of this Navigation System, other cables
or leads:
TV aerial and aerial lead
FM, MW/LW aerial and its lead
GPS aerial and its lead
In addition you should lay or route each aerial
lead as far as possible from other aerial leads.
Do not bind them together, lay or route them
together, or cross them.
Such electromagnetic noise will increase the
potential for errors in the location display.
Before installing
Consult with your nearest dealer if installation
requires the drilling of holes or other modifi-
cations of the vehicle.
Before finally installing the unit, connect the
wiring temporarily, making sure it is all con-
nected up properly, and the unit and the sys-
tem work properly.
Installation notes
Do not install this unit in places where it may
become subject to high temperatures or
humidity, such as:
* Places close to a heater, vent or air condi-
tioner.
* Places exposed to direct sunlight, such as
on top of the dashboard or the rear shelf.
* Places that may be splashed by rain, for
example close to the door.
When installing the unit choose a position
that is strong enough to bear the weight of
the unit. Choose a position where this unit
can be firmly installed, and install it securely.
Unless this unit are securely attached, the
current location of the vehicle cannot be dis-
played correctly.
Check that a disc can be ejected with this unit
installed.
Install this unit horizontally on a surface
within +30 degrees to 0 degrees tolerance
(within five degrees to the left or right of your
vehicles direction of travel). Mis-installing the
unit with the surface tilted more than these
tolerances would increase the potential for
errors in the location display, and might oth-
erwise cause reduced display performance.
The cords must not cover up the area shown
in the figure below. This is necessary to allow
the amplifiers and navigation mechanism to
dissipate heat freely.
The semiconductor laser will be damaged if it
overheats, so dont install the unit anywhere
hot for instance, near a heater outlet.
Do not close this area.
30°
5°
CRD3863A_inst_002-029_UK 4/9/04 2:05 PM Page 16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer anh-p10mp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer anh-p10mp in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer anh-p10mp

Pioneer anh-p10mp User Manual - English - 109 pages

Pioneer anh-p10mp User Manual - German - 124 pages

Pioneer anh-p10mp User Manual - Dutch - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info