162112
88
Zoom out
Zoom in
Previous page
1/109
Next page
Audio Adjustments
En
11
Section
88
2Press LOUD to turn the loudness on.
LOUDNESS ON” appears in the display.
Press LOUD again to turn loudness off.
3 Select the desired level with
or
.
Press
or
until the desired level appears in
the display.
LOWMIDHIGH
Using subwoofer output
This product is equipped with a subwoofer
output which can be switched on or off. When
a subwoofer is connected to the rear output,
first, switch the rear output setting to
SUB.W”, then turn the subwoofer output on.
For more details, refer to Setting the rear out-
put and subwoofer controller on page 94.
1Press AUDIO and then press NEXT.
2Press SW 1 to select the subwoofer
output mode.
When the subwoofer controller setting is
FULL Preout :FULL”, you cannot select “SW 1”.
3Press SW 1 to turn the subwoofer out-
put on.
SUB. W ON” appears in the display.
Press SW 1 again to turn subwoofer out-
put off.
4Press
or
to select the phase of sub-
woofer output.
Press
to select reverse phase and the
speaker appears facing downward. Press
to
select normal phase and the speaker appears
facing upward.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1Press AUDIO and then press NEXT.
2Press SW 2 to select the subwoofer
setting mode.
When the subwoofer output is on, you can se-
lect SW 2.
3Press
or
to select cut-off frequen-
cy.
Each press of
or
selects cut-off frequen-
cies in the following order:
5080125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer
(low pass filter).
4Press
or
to adjust the output level
of the subwoofer.
Each press of
or
increases or decreases
the level of the subwoofer. “+6” – “–6” is dis-
played as the level is increased or de-
creased.
Using nonfading output
When the non fading output setting is on, the
audio signal does not pass through this prod-
uct’s low pass filter (for the subwoofer), but is
output through the RCA output.
1Press AUDIO and then press NEXT.
2Press NoFAD1 to select nonfading out-
put on/off setting mode.
Only when the subwoofer controller setting is
FULL Preout :FULL”, you can switch to the non-
fading output on/off setting. (Refer to Setting the
rear output and subwoofer controller on page 94.)
88


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer anh-p10mp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer anh-p10mp in the language / languages: English as an attachment in your email.

The manual is 1,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer anh-p10mp

Pioneer anh-p10mp Installation Guide - English, German - 170 pages

Pioneer anh-p10mp User Manual - German - 124 pages

Pioneer anh-p10mp Installation Guide - Dutch - 170 pages

Pioneer anh-p10mp User Manual - Dutch - 120 pages

Pioneer anh-p10mp Installation Guide - French, Italian, Spanish - 170 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info