455176
8
Zoom out
Zoom in
Previous page
1/99
Next page
Connecting up02
8
En
Connect any other components (such as
an iPod
1
dock or a portable audio player) to
the AUX and TUNER inputs in the same
way.
2 Connect the analog outputs of your tape
deck (or other recorder) to the TAPE inputs
(IN) on this amplifier. Then connect the audio
inputs on the tape deck to the TAPE outputs
(OUT) on this amplifier.
This will allow you to make recordings from the
components connected to this amplifier. Use
stereo RCA phono cables as shown.
3
Turntables only:
Connect the audio
outputs of your turntable to the PHONO
inputs on this amplifier.
If your turntable has a grounding wire,
secure it to the ground terminal on this
amplifier.
If your turntable has line-level outputs (i.e.,
it has a built-in phono pre-amp), connect it
to the AUX inputs instead.
Connecting the speakers
Make sure you connect the speaker on the
right to the right terminal and the speaker on
the left to the left terminal. Also make sure the
positive and negative (+/–) terminals on the
amplifier match those on the speakers. You
can use speakers with a nominal impedance
between 4 Ω to 16 Ω.
Be sure to complete all connections before
connecting this unit to the AC power source.
Connect the speakers to the speaker
terminals as shown above.
Connections for the left speaker are shown.
Connect the right speaker in the same way. You
can use either bare wire connections to do this
(see below).
Bare wire connections
Make sure that the speaker cable you’re going
to use is properly prepared with about 10 mm
of insulator stripped from each wire, and the
exposed wire strands twisted together (fig. A).
To connect a terminal, unscrew the terminal a
few turns until there is enough space to insert
the exposed wire (fig. B). Once the wire is in
position, tighten the terminal until the wire is
firmly clamped (fig. C).
Important
Please refer to the manual that came with
your speakers for details on how to connect
the other end of the speaker cables to your
speakers.
Note
1 iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
PHONO
L
R
GND
AC IN
SPEAKER L
SIGNAL
CONTROL
OUT
Left speaker
10 mm
fig. A fig. B fig. C
A6MK2_SYXCN5.book 8 ページ 2009年4月7日 火曜日 午前11時18分
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer A-A6MK2-K at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer A-A6MK2-K in the language / languages: English, German, Dutch, French, Italian, Spanish, Spanish as an attachment in your email.

The manual is 9,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info