651674
5
Zoom out
Zoom in
Previous page
1/116
Next page
Connecting up 02
5
En
English
DeutschFrançais
Nederlands
Italiano Español Русский
Chapter 2:
Connecting up
Making cable connections
Caution
Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.
Connect the power cord after all the connections between devices have been completed.
REC
R
L
RL
PLAY
RL
AUDIO
OUTPUT
PRE OUT
R
L
NORMAL
NORMAL
INVERSION
INVERSION
PHASE
PHASE
LINE2
LINE2
LINE1
LINE1
USB
USB
COAXIAL
COAXIAL
PHONO
PHONO
(MM/MC)
(MM/MC)
SIGNAL
SIGNAL
GND
GND
NETWORK
NETWORK
SACD/CD
SACD/CD
DIGITAL IN
DIGITAL IN
ANALOG IN
ANALOG IN
OPTICAL
OPTICAL
LINE2
LINE2
OUT
OUT
POWER
POWER
AMP
AMP
DIRECT
DIRECT
BALANCED IN
BALANCED IN
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
MENU
iPod

Music>
Extras>
Settings>
Shuffle Songs
Backlight
MASTER
VOLUME
STANDBY/ON
INPUT
SELECTOR
iPod iPhone iPadHDMI
ADVANCED
MCACC
FL OFF
SOURCE
/I STANDBY/ON
STANDBY
iPod/iPhone
5V 1A
DIRECT Hi-Bit 32 Up Sampling
SOURCE
 
SACD/CD player
Network audio player
PRE OUT jacks on pre-
amplifier or AV amplifier
Speaker system B
Speaker system A
Turntable
Audio device with
balanced output terminals
iPod dock, etc.
Recording device
or other device
Right Left
Right
Left
Power cord
(included)
This unit’s
rear panel
Caution
•The SIGNAL GND terminal is provided to reduce
noise when connecting the unit to components
such as an analog turntable.
•The PHONO IN terminals are factory equipped with
short pin plugs. These should not be removed
except when connecting a turntable. Be sure to
save the short pin plugs in a safe place.
Do not insert the short pin plugs in any connectors
other than the PHONO IN terminals. Connecting
them to any other terminals may cause
malfunctions.
Do not connect the PHONO IN terminals to any
component other than a turntable; also, do not
connect to a turntable equipped with built-in
equalizer. An excessively high sound output may be
produced, resulting in damage to your speakers or
other devices.
The A-50DA’s PHONO IN terminals are designed to
be used only with turntables equipped with MM
(moving-magnet) type cartridges. Turntables
equipped with MC (moving-coil) cartridges cannot
be used.
Make sure not to bend the cables over the top of
this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a humming
noise from the speakers.
The unit’s POWER AMP DIRECT terminals should
never be connected to any other component’s
connectors except PRE-AMP OUT.
If your turntable has a grounding wire, secure it to
the ground terminal on this amplifier.
Note
When connecting a tape cassette deck, playback
noise may be heard, depending on the installation
location. This noise is caused by leakage flux from
the amplifier’s transformer. In this event, change
the installation location, or move the deck farther
from the amplifier.
iPod is a trademark of Apple Inc., registered in the
U.S. and other countries.
About “Bi-wiring”
This unit can be used with speakers that support bi-
wiring. Be sure to connect the high-frequency and
low-frequency connections correctly.
During playback, be sure that both the SPEAKERS
A button and SPEAKERS B button are set to ON
(page 8).
Caution
When using bi-wiring to connect speakers, avoid
adverse affects on the amplifier by being sure to
remove the HIGH and LOW short bars provided
with the speakers. For detailed information, consult
the instructions provided with the speakers.
HIGH
LOW
HIGH
LOW
A70_SYXE8_0728.book 5 ページ 2015年7月28日 火曜日 午後3時54分
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer A-70DA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer A-70DA in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 23,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info