677799
13
Zoom out
Zoom in
Previous page
1/103
Next page
Step 1:
Putting on the carrying
harness, place the shoulder
strap loop over head and
shoulder. Lead the body strap


proper length.
Step 2:
Switch on the PIEPS DSP PRO/
DSP SPORT (SEND) and wait
for the results of the self-check.
Step 3:
Put the PIEPS DSP PRO/DSP
SPORT back into the carrying

QUICKSTART IN 3 STEPS
Your PIEPS DSP PRO/DSP SPORT

WARNING!
The volume level of an avalanche
transceiver can be up to 100 dB
(decibels), and may cause damages
to your hearing! Make sure that
there is always a minimum distance
of 50 cm between the avalanche
transceiver and your ears!
DEENESFRITCZSKSIRUJP
  PIEPS recommends
carrying the PIEPS DSP PRO/DSP SPORT using the
supplied carrying harness. The neoprene-material
is water repellent, for the functional control take a
look on the transmit light, the “Quick-Pull-System”
enables you to access the PIEPS DSP PRO/DSP
SPORT very quickly in case of emergency. Insert the
beacon with the display towards the body for best
protection (see picture).
There is also the option to carry the PIEPS DSP PRO/
DSP SPORT with the supplied hand loop in a securely
closeable trouser pocket without a protective case.

the search to rule out losing the PIEPS DSP PRO/DSP
SPORT.
„Quick-Pull-System“
SWITCHING ON | SELF-CHECK
Press the button „Lock“ and push the main switch up to the position „SEARCH“. Release the
button „Lock“ and push down the main switch till latching noticeable in the position „SEND“.
The PIEPS DSP PRO/DSP SPORT is now in SEND-mode.
During power-on, the PIEPS DSP PRO/DSP SPORT will carry out an extensive self-check. All
           
self-check, a minimum distance of 5 meters should be maintained to other beacons, and any
electronic or magnetic interference.
If the self-check is successful, “OK“ is indicated on the display. In the event of a device warning,
an alert signal sounds and the display indicates “E“ in combination with a warning-code
(overview table in chapter warning-codes). If the warnings are still shown in an interference-
free area the PIEPS DSP PRO/DSP SPORT is not fully functional. Bring your PIEPS DSP PRO/DSP
SPORT to a PIEPS authorized service center.
BEACON-CHECK | GROUP-CHECK
Despite the extensive self-check, PIEPS recommends that all users perform a beacon check
before each tour! Your PIEPS DSP PRO/DSP SPORT is equipped with a group-check-function. A

signal and whether the frequency is in compliance with standards.
Display
Firmware-Version
Display
Self-check OK
Display
Self-check error
06/15 ||
06/15 2524
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pieps DSP SPORT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pieps DSP SPORT in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 5,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info