The pellet stove is a different type of heater. Its operation and maintenance differ from the traditional wood stove. Follow these operating instructions
exactly as stated to ensure safe and reliable operation.
• Do not use the stove as a cooking appliance.
• Ensure that the room in which the stove is installed is sufciently well ventilated (fresh air intake).
• A certain amount of carbon monoxide may be produced within the stove as a by-product of combustion. All exhaust vent connections must be
sealed with RTV silicone to assure a gas tight seal. Any leaks into a conned area caused by faulty installation or improper operation of the stove
could produce dizziness, nausea and in extreme cases, death.
• Check (or have checked) regularly that the ue is clean.
• Under no circumstances use fuels other than pellets.
• Remove any deposits of unused pellets left by failed ignition before restarting the stove.
aDirect contact with the stove while operating may cause skin burns.
aDuring operation some parts of the stove (door, handle, controls, ceramic parts) can reach high temperatures. Take great care and all
the necessary precautions, especially in the presence of children, the elderly or disabled and pets.
Keep any inammable object well away from the stove while it is in use (MINIMUM 32” - 80 cm) from the front panel.
While in use the door must remain closed and the glass must be present and intact.
The removal of the protective grille inside the pellet hopper is strictly prohibited.
If replenishing with pellets while the stove is lit, ensure that the bag does not come into contact with any hot surfaces.
aOperate this unit only with the fuel hopper lid closed. Failure to do so may result in emission of products of combustion from the
hopper under certain conditions. Maintain hopper seal in good condition.
DT2010035-06
DT2010730-00
6.1 LOADING THE PELLETS
Fig. 56
• When lighting your stove for the rst time, or any time you have run
out of Pellets, you will need to ll the hopper. Pellets are fed from the
hopper to the burn pot by an auger. A high torque motor that is capable
of doing serious harm to ngers drives the auger and for this reason in
Piazzetta pellet stoves a protective grille inside the hopper is placed.
To open the pellet hopper, pull the upper panel and then lift the hopper lid.
dDon’t remove the protective grill inside the pellet hopper.
• To load the pellets into the hopper it is advisable to tear off the edge of
the sack and empty the sack directly into the hopper. This makes lling
easier and avoids pouring pellets on top of the stove.
dDo not allow sawdust to accumulate on the bottom of the
hopper.
dDo not leave leftover pellets on top of the stove – they could
catch re!
dDo not overll the hopper.
aMaintain the hopper seal in good condition.
dDO NOT RELOAD WITH PELLETS WHEN THE APPLIANCE IS LIT if the red
reload indicator inside the pellet hopper is visible (see gure to the side).
To load with pellets if the red reload indicator is visible, proceed as follows:
-shut down the appliance;
-load the hopper as described above.
The auger must have the time to ll; during this stage the pellets are not
distributed inside the rebox and it is more than likely that the rst attempt to
ignite the appliance fails; empty and clean the great. Lighting again the stove.
If an alarm is triggered, deactivate the appliance by pressing the ON/
OFF key for a few moments, remove the fuel to be found in the grate
and set a new ignition cycle.
Any unburned pellets to be found in the grate must be disposed of.
The appliance has a system that controls the opening of the hopper lid.
At each opening of the hopper lid, the appliance interrupts fuel supply.
Fig. 57
Fig. 58
aIf the sliding top panel remains open for more than 60
consecutive seconds, the stove starts the shut-down procedure
after a 30-second audible beep activates to request that the
sliding top panel be fully closed. The hopper lid must be closed
before sliding the panel into its fully closed position.
aIn circumstances where the sliding top panel is left not in its fully
closed position a 30 second audible beep will be activated requesting
the sliding top panel to be manually returned to its fully closed
position, otherwise the stove will go into shut-down procedure.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Piazzetta P963 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Piazzetta P963 in the language / languages: English as an attachment in your email.
The manual is 4,78 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
