492022
4
Zoom out
Zoom in
Previous page
1/12
Next page
Amplier Owners Manual
© 2011 Phoenix Gold • www.phoenixgold.com
FRONT AND REAR INPUTS
Connect preamp signal cables from headunit to these inputs. The front
AND rear inputs must be used, if only the front input is used then the rear
speaker outputs will have no output signal.
CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs.
BASS BOOST
Variable bass boost from 0 to +18dB @ 45Hz.
SENS
Used to reach maximum amplier power with a wide variety of headunits.
CONFIG
FLAT: Crossovers are turned o
HPF: High pass crossover is on
LPF: Low pass crossover is on
+12V
This must be connected to the fused positive terminal (+12V) of the cars
battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to switched +12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car’s battery or
bolted to a clean, unpainted part of the chassis of the vehicle.
SPEAKER OUTPUTS
Used to connect the amplier to speakers. SD500.4 minimum impedance
is 4 ohm bridged or 2 ohm stereo. Use Right + and Left - to bridge the
channels.
sD500.4
4 Channel Power Amplifier
INPUT
RR
RL
FR
FL
FREQ
40Hz 400Hz
X OVER
LPF
FLAT
HPF
BASSBOOST
0d B 18dB
SENS
MIN MAX
SENS
MIN MAX
FREQ
40Hz 400Hz
BASSBOOST
0d B 18dB
X OVER
HPF
FLAT
LPF
POWER
FL
GROUND REMOTE + 12V
FUSE
25A 25A
FR
RL RR
+ 12VR
GROUND REMOTE + 12V
FUSE
30A30A
SPEAKER
GROU N D + 12VR
POWER
SENS
MIN MAX
BASS
0d B 18dB
X-OVER
FREQ.
30Hz 30 0Hz
REMOTE
PROTECT
SUBSONIC
10Hz 55Hz
L
R
INPUT
PROTECT
POWER
REMOTE
SUB INPUT
R
MIN MAX
MIN MAX
SENS
SENS BASS BOOS T
0d B 18dB
HPF
15Hz 25 0Hz
HPF
15Hz 25 0Hz MIN MAX
SENS
30Hz
LP F
300Hz
GROUND REMOTE + 12V
FUSE
30A
FL
30A
SUB.
SUB.
INPUT
RR
RL
FR
FL
SUB INPUT
L
S UB FRONT
FRONT REAR
FR
RL RR
GROU N D + 12VR
GROU N D
NOTE: Visible through the plexiglass cover, a single blue power LED is located in the lower corner of all SD ampliers.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Phoenix Gold SD600.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Phoenix Gold SD600.1 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info