4. Extra possibilities
Learn a key
If you miss certain functions from your original remote control on the
SRU 7040, the SRU 7040 can learn these functions from the original remote
control.You can store a fuction under any of the available keys of the
SRU 7040, except LEARN, SELECT and SHIFT. Please, note that any function
already stored under a key will be deleted.
Example for VCR:
Make sure you have the original VCR remote control at hand.
1 Press the SELECT key to select VCR.
Press the key until the VCR LED lights up.
2 Press the LEARN key and the target key on
the SRU 7040 simultaneously for 5 seconds,
until the VCR LED blinks twice and then
remains lit.
3 Place both remote controls on a flat surface
(like a coffee table) and aim them head-to-
head with about 5 - 10 cm in between.
4 Press the button you want to copy on the original remote control.
– If the SRU 7040 has learned the code, the VCR LED blinks twice to
confirm the signal is stored.
– If the LED blinks once for a longer period, the IR signal is not learned by
the SRU 7040. Please, try a few times and make sure the remote
controls are aligned as described in step 3.
If the SRU 7040 cannot learn the code after several times trying,
it is possible that:
– The IR signal of your original device is out of range (the SRU 7040 can
only learn IR signals with a carrier signal of 30-60kHz.
– The memory of the SRU 7040 is full.
– The SRU 7040 stopped the learning process after 20 seconds if no
IR signals are found. Check if your original remote control is working
correctly.
9
Instructions for use
English
