3 Check whether all keys are working.
For an overview of the keys and their
functions see ‘3. Keys and functions’.
– If the TV responds as it should to all of the
key commands the SRU540 is ready for use.
• If the device does not respond at all or not to all of the
key commands, follow the instructions under
‘Setting the remote control’, or for online setup go to:
www.philips.com/urc.
Setting the remote control
This is only necessary if your device does not respond to the SRU540.
If that is the case, the SRU540 does not recognize the brand and/or model of
your device and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.You can repeat the
same steps for other devices (DVD player/recorder, video recorder, etc.)
which you want to operate using the SRU540.
Automatically setting the remote control
The remote control will now automatically search for the right code for your
device.
Example of TV:
1 Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU540 emits the ‘switch off TV’ signal for all models of TV that are
stored in the memory.
• If the device is a DVD player/recorder or video recorder,
insert a disk or tape and start playback.
2 Press the SELECT key to select TV.
Press the key until TV lights up in the selector
window.
3 Then keep keys 1 and 3 pressed
simultaneously for five seconds until TV in the
selector window flashes twice and then
remains lit.
4 Press and hold the Standby key of the
SRU540.
– The SRU540 now starts emitting all known
‘TV off ’ signals, one by one.
Each time a code is sent,TV in the selector
window lights up.
5
Instructions for use
English
