811249
8
Zoom out
Zoom in
Previous page
1/24
Next page
8 Philips · Screeneo U4
4 Connect the power cable to an electrical
socket.
The power LED on the projector lights
up in red.
d
c
ab
Prepare the remote control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
When using a remote control with infrared
signals, point the remote control at the IR
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.
Power on and set up the
projector
Power on/off the projector
To turn on the projector, press and hold
on the projector for 2 seconds or press
on the remote control. The power LED on
the projector turns from red to white.
To turn off the projector, press and hold
on the projector/remote control for 2
seconds or press this button twice. The
projector enters standby mode and its
power LED turns from white to red.
To fully shut down the projector, disconnect
the power cable from the electrical socket.
Set up the projector system
When you turn on the projector for the first
time or after it was reset to its factory default
settings, the projector system will start and
prompt you to set it up by making some basic
settings.
After the setup, you can start using the projector
or continue to make other adjustments.
Step 1: Select the display language
Press the down or up navigation button on the
remote control to select your preferred display
language and press the OK button to confirm.
Note: The default display language is English
and not all languages are available.
Step 2: Adjust the projector's position
Adjust the projector's position to get the
optimal screen shape and size.
When you are done, press the OK button.
Step 3: Set the date and time
Press the down or up navigation button on
the remote control to set the values for the
date and time. Press the right or left navigation
button to move to the next or previous value.
When you are done, press the right navigation
button to select Next and press the OK button.
You will see the home screen shown below
after completing the setup.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips SCN350 Screeneo U4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips SCN350 Screeneo U4 in the language / languages: English as an attachment in your email.

The manual is 8.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips SCN350 Screeneo U4

Philips SCN350 Screeneo U4 User Manual - German - 28 pages

Philips SCN350 Screeneo U4 User Manual - Dutch - 25 pages

Philips SCN350 Screeneo U4 User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info