527155
16
Zoom out
Zoom in
Previous page
1/134
Next page
3
Follow steps 2-6 of the previous section (‘Before rst use and skin test’).
Note: It is normal that the appliance and the body attachment become warm
during use.
4 Slide the appliance over the skin to the next area to be treated
and repeat steps 5 and 6 of section ‘First use and skin test’ in this
chapter.After each ash, it takes up to 3.5 seconds until the appliance 
is ready to ash again.The ‘ready to ash’ light on the back of the 
appliance starts blinking again to indicate that it is charging. Wait until
this light lights up continuously before you continue.
Tip for SC1992: The SC1992 has a ‘slide and ash’ feature: for a more efcient
treatment, keep the ash button pressed while you slide the appliance over
your skin.
Do not treat exactly the same area multiple times during one session.
This does not improve the effectiveness of the treatment, but increases 
the risk of skin reactions.
5 To avoid untreated areas, make sure the ashes are produced close 
to each other. Note that effective light only comes out of the light
exit window. However, always make sure you do not ash the same 
area twice.
6 When you have nished the treatment, press and hold the on/off 
button for 2 seconds to switch off the appliance.
7 Check the light exit window and the body attachment for hairs and
dirt and clean the appliance after use (see chapter ‘Cleaning and
maintenance’).
Tips
How to achieve optimal results
- It is normal that hairs are still visible after the rst few treatments (see
chapter ‘Introduction’, section ‘Working principle’ for more information).
- To remove all hairs successfully and prevent the hair follicle from
becoming active again, the treatments have to be repeated once every
two weeks for the rst two months. Your skin should be smooth and
hair-free by then. Please read section ‘Maintenance phase’ to nd out
how you can keep these results.
Maintenance phase
- To ensure that your skin stays smooth and hair-free, we advise you
to repeat the treatment every four to six weeks. The time between
treatments may vary based on your individual hair regrowth and also
across different body areas. If too many hairs grow back between
treatments, simply shorten the treatment interval again, but do not
treat any area more often than once every two weeks. When you use
the appliance more frequently than recommended, you do not increase
the effectiveness but you do increase the risk of skin reactions.
ENGLISH16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips SC1991 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips SC1991 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Philips SC1991

Philips SC1991 Quick start guide - Dutch - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info