User Guide
5
4 Place the battery cover back on.
Note Make sure the cable of the battery pack does not get stuck between the
mould and the battery cover.
After a few seconds, the Remote Control starts up automatically and an
Introduction screen appears. The Remote Control beeps twice to indicate that
it has finished starting up.
Because the battery pack of the Remote Control is not fully pre-charged, you
will have to charge it as described below.
Charging the Remote Control
For charging the Remote Control you use the docking station.
1 Plug the power adapter into a wall outlet and connect it to the docking
station.
2 Place the Remote Control in the docking station.
Make sure you hold the Remote
Control at an angle of 30° to 45°
when you place the it in the
docking station.
Charging starts immediately. The green charging LED on the front of the
docking station indicates charging takes place. When the Remote Control is
fully charged, the LED goes off.
Note Normal charging time is 2 to 3 hours, depending on the condition of the
battery pack.
You can operate the Remote Control while it is being charged.
The battery pack does not have to be entirely empty before recharging.
You can place the Remote Control in the docking station at any time.
When the battery pack is running low, the Low Battery icon flashes on the
Remote Control icon . Recharge the Remote Control as soon as possible to
ensure perfect performance.
Note The Remote Control retains all settings when the battery pack has run out.
You will only have to set the clock. See “Adjusting the Settings” on page 18.
Taking a First Look
30° to 45°