1848
4
Zoom out
Zoom in
Previous page
1/35
Next page
6 7
O
P
E
N
-
S
E
N
S
I
T
I
V
I
T
Y
+
4
3
5
-
S
E
N
S
I
T
I
V
I
T
Y
+
4
3
5
ENGLISHENGLISH
Problem solving
Possible cause
PP
PP
P
arent unit:arent unit:
arent unit:arent unit:
arent unit: unit is not turned on.
Batteries are low.
BabBab
BabBab
Bab
y unit:y unit:
y unit:y unit:
y unit: unit is not turned on.
Power adapter is not plugged in or
batteries are exhausted.
Units are too close together.
Battery life is at an end.
Volume on parent unit is set too
low.
Batteries are low or empty.
Mobile or cordless phones too close
to the baby monitor.
Both systems are operating on the
same frequency.
Units are out of range or there is
interference from another FM
source.
Solution
Turn VOLUME ON/OFF control
downwards.
Recharge batteries.
Push power button.
Plug in power adapter or replace
batteries.
Move parent unit away from baby
unit. Turn VOLUME ON/OFF
control on parent unit upwards.
Connect charging base to mains
power. Replace battery pack.
Turn VOLUME ON/OFF control
downwards.
Parent unit:- recharge battery pack.
Baby unit:- replace batteries or
connect to mains power.
Move phones away from the units.
Switch channels.
Move units closer together to
restore the link. Remove the other
FM source.
Problem
Power light does not
light.
High pitched noise.
Parent unit batteries
do not charge.
No sound.
Power light flashing.
Interference or poor
reception.
Pick-up from another
baby monitor.
System check light
flashing (red) /
System check alarm.
Using batteries
Operating the Baby unit cordlessly
Remove the battery compartment cover using a coin.
Insert four 1.5V, LR6 (AA) batteries noting the + and - configuration
inside the battery compartment.
Batteries not included; we recommend non-chargeable Philips Alkaline
batteries.
Put the cover back in place and secure using a coin.
> If the power light flashes (red) install new batteries.
The unit operates for up to 30 hours on batteries.
Replacing the Parent unit’s battery pack
Open the Parent unit’s battery compartment cover.
Disconnect the old battery pack from the power plug and remove.
Carefully connect the new battery pack to the power plug and place
inside the battery compartment.
Close battery compartment cover.
Batteries
Dispose of used batteries in an environmentally friendly manner.
Do not mix old and new batteries, or different types of batteries.
Remove Baby unit batteries if the baby monitor is not to be used for long
periods.
1
2
3
1
2
3
4
Power supply:
Operating range:
Operating temperature:
Digital Pilot tone:
Transmission frequencies:
Technical specifications
Battery pack; rechargeable NiMH for Parent unit (included);
Optional batteries 4 x 1.5V; AA alkaline for Baby unit (not included);
AC power adapter 230V AC, 50 Hz (two included): - Output voltage 9V DC, 200mA.
Only use the AC power adapter included or a type that complies with safety standard EN60950
and that has the following specification: input 230V AC, 50 Hz; output 9 Volt DC / 200mA.
up to 250 metres in ideal conditions (walls, floors, etc. can limit this distance.)
10°C to 40°C
Continuous communication link (hidden signal helps reduce interference and ensures a
continuous link between both units so you only hear your baby’s sounds).
SBC SC465/00: from 40.695 to 40.675 MHz
SBC SC465/05 (IRE, UK): from 49.830 to 40.890 MHz
SBC SC465/16 (ES): from 31.000 to 31.350 MHz
IFU465.p65 16/01/2002, 10:226-7
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips SBC SC465 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips SBC SC465 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info