8
English
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
would invalidate the warranty.
Problem Remedy
No sound – Check if the AC/DC adapter is fully inserted into the
AC outlet and that its DC connector is properly inserted
into the 12 Volt DC input connector located at the rear
of the transmitter.
– Check if the headphone’s on/off switch is in the on
position.
– Headphone batteries running low. Remove the
earcushions.Take out the batteries and put them in the
transmitter’s recharging compartment for recharging.
(See Headphone power supply)
– Check if the audio source is switched on and tuned to
a channel with audio.
– Volume not adjusted.Adjust the volume on the audio
source/ headphone to a higher level.
– Adjust the headphone’s tuning frequency.Turn the
tuning wheel until the signal is at its clearest.
– Make use of the HC8352 transmitter. Some
transmitters already built into other equipment may not
be compatible with the HC8355 headphone because of
the advanced technologies used in the HC8355
headphone.
Distorted sound – Adjust the headphone’s tuning frequency.Turn the tuning
wheel until the signal is at its clearest.
– Adjust the transmitter’s frequency. Select any of the
2 channels of the transmitter. Next adjust the
headphone’s frequency by turning the tuning wheel until
the signal is at its clearest.
– Headphone batteries running low. Remove the
earcushions.Take out the batteries and put them in the
transmitter’s recharging compartment for recharging.
(See Headphone power supply)
XP SBC HC 8350/00-1 11-06-2001 10:48 Pagina 8
